HD64F7047FW40V Renesas Electronics America, HD64F7047FW40V Datasheet - Page 160

• Manufacturer Part Number: HD64F7047FW40V
• Description: MCU 5V 256K I-TEMP,PB-FREE 100-Q
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7047r

Specifications of HD64F7047FW40V

• Core Processor: SH-2
• Core Size: 32-Bit
• Speed: 40MHz
• Connectivity: CAN, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 53
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 12K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

8.3
8.3.1
The DTC operates when activated by an interrupt or by a write to DTCSR by software. An
interrupt request can be directed to the CPU or DTC, as designated by the corresponding DTER
bit. At the end of a data transfer (or the last consecutive transfer in the case of chain transfer), the
activation source interrupt flag or corresponding DTER bit is cleared. The activation source flag,
in the case of RXI_2, for example, is the RDRF flag of SCI2.
When a DTC is activated by an interrupt, existing CPU mask level and interrupt controller
priorities have no effect. If there is more than one activation source at the same time, the DTC
operates in accordance with the default priorities.
Figure 8.2 shows a block diagram of activation source control. For details see section 6, Interrupt
Controller (INTC).
8.3.2
Figure 8.3 shows the allocation of register information in memory space. The register information
start addresses are designated by DTBR for the upper 16 bits, and the DTC vector table for the
lower 16 bits.
The allocation in order from the register information start address in normal mode is DTMR,
DTCRA, 4 bytes empty (no effect on DTC operation), DTSAR, then DTDAR. In repeat mode it is
DTMR, DTCRA, DTIAR, DTSAR, and DTDAR. In block transfer mode, it is DTMR, DTCRA, 2
bytes empty (no effect on DTC operation), DTCRB, DTSAR, then DTDAR.
Fundamentally, certain RAM areas are designated for addresses storing register information.
Rev. 2.00, 09/04, page 118 of 720
Operation
Activation Sources
Location of Register Information and DTC Vector Table
IRQ
on-chip
peripheral
Figure 8.2 Activating Source Control Block Diagram
Interrupt requests
Source flag clear
Clear
DTC control
DTER
DTC
DTC activation
request
CPU interrupt requests
(those not designated as
DTC activating sources)
INTC