W78E052DDG Nuvoton Technology Corporation of America, W78E052DDG Datasheet - Page 58

• Manufacturer Part Number: W78E052DDG
• Description: IC MCU 8-BIT 8K FLASH 40-DIP
• Manufacturer: Nuvoton Technology Corporation of America
• Series: W78r

Specifications of W78E052DDG

• Core Processor: 8052
• Core Size: 8-Bit
• Speed: 40MHz
• Connectivity: EBI/EMI, UART/USART
• Peripherals: POR, WDT
• Number Of I /o: 36
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Ram Size: 256 x 8
• Voltage - Supply (vcc/vdd): 2.4 V ~ 5.5 V
• Oscillator Type: External
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 40-DIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -

W78E054D/W78E052D/W78E051D Data Sheet
Figure 16- 1 Serial port mode 0
The TI flag is set high in S6P2 following the end of transmission of the last bit. The serial port will re-
ceive data when REN is 1 and RI is zero. The shift clock (TxD) will be activated and the serial port will
latch data on the rising edge of shift clock. The external device should therefore present data on the
falling edge on the shift clock. This process continues till all the 8 bits have been received. The RI flag
is set in S6P2 following the last rising edge of the shift clock on TxD. This will stop reception, till the RI
is cleared by software.
16.2 MODE 1
In Mode 1, the full duplex asynchronous mode is used. Serial communication frames are made up of
10 bits transmitted on TXD and received on RXD. The 10 bits consist of a start bit (0), 8 data bits (LSB
first), and a stop bit (1). On receive, the stop bit goes into RB8 in the SFR SCON. The baud rate in this
mode is variable. The serial baud can be programmed to be 1/16 or 1/32 of the Timer 1 overflow.
Since the Timer 1 can be set to different reload values, a wide variation in baud rates is possible.
Transmission begins with a write to SBUF. The serial data is brought out on to TxD pin at S6P2 follow-
ing the first roll-over of divide by 16 counter. The next bit is placed on TxD pin at S6P2 following the
next rollover of the divide by 16 counter. Thus the transmission is synchronized to the divide by 16
counter and not directly to the write to SBUF signal. After all 8 bits of data are transmitted, the stop bit
is transmitted. The TI flag is set in the S6P2 state after the stop bit has been put out on TxD pin. This
will be at the 10th rollover of the divide by 16 counters after a write to SBUF.
Reception is enabled only if REN is high. The serial port actually starts the receiving of serial data,
with the detection of a falling edge on the RxD pin. The 1-to-0 detector continuously monitors the RxD
line, sampling it at the rate of 16 times the selected baud rate. When a falling edge is detected, the
divide by 16 counters is immediately reset. This helps to align the bit boundaries with the rollovers of
the divide by 16 counters.
- 58 -