HD64F3048F16 Renesas Electronics America, HD64F3048F16 Datasheet - Page 186

• Manufacturer Part Number: HD64F3048F16
• Description: IC H8 MCU FLASH 128K 100QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD64F3048F16

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Package: 100PQFP
• Family Name: H8
• Maximum Speed: 16 MHz
• Operating Supply Voltage: 5 V
• Data Bus Width: 16|32 Bit
• Number Of Programmable I/os: 70
• Interface Type: SCI
• On-chip Adc: 8-chx10-bit
• On-chip Dac: 2-chx8-bit
• Number Of Timers: 5
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 6 Bus Controller
6.4.3
After driving the BREQ pin low, hold it low until BACK goes low. If BREQ returns to the high
level before BACK goes low, the bus arbiter may operate incorrectly.
To terminate the external-bus-released state, hold the BREQ signal high for at least three states. If
BREQ is high for too short an interval, the bus arbiter may operate incorrectly.
6.4.4
If contention occurs between a transition to software standby mode and a bus request from an
external bus master, the bus may be released for one state just before the transition to software
standby mode (see figure 6.23). When using software standby mode, clear the BRLE bit to 0 in
BRCR before executing the SLEEP instruction.
Rev. 3.00 Sep 27, 2006 page 158 of 872
REJ09B0325-0300
BREQ
BACK
Address bus
Strobe
Figure 6.23 Contention between Bus-Released State and Software Standby Mode
BREQ Input Timing
BREQ
Transition To Software Standby Mode
BREQ
BREQ
Bus-released state
Software standby mode