HD64F3048F16 Renesas Electronics America, HD64F3048F16 Datasheet - Page 615

• Manufacturer Part Number: HD64F3048F16
• Description: IC H8 MCU FLASH 128K 100QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD64F3048F16

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 8MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Package: 100PQFP
• Family Name: H8
• Maximum Speed: 16 MHz
• Operating Supply Voltage: 5 V
• Data Bus Width: 16|32 Bit
• Number Of Programmable I/os: 70
• Interface Type: SCI
• On-chip Adc: 8-chx10-bit
• On-chip Dac: 2-chx8-bit
• Number Of Timers: 5
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Bit 2—Program-Verify Bit (PV): Selects program-verify mode transition or clearing (applicable
addresses: H'00000 to H'1FFFF). Do not set the SWE, ESU, PSU, EV, E, or P bit at the same time.
Bit 2: PV
0
1
Bit 1—Erase Bit (E): Selects erase mode transition or clearing (applicable addresses: H'00000 to
H'1FFFF). Do not set the SWE, ESU, PSU, EV, PV, or P bit at the same time.
Bit 1: E
0
1
Note:
Bit 0—Program Bit (P): Selects program mode transition or clearing (applicable addresses:
H'00000 to H'1FFFF). Do not set the SWE, PSU, ESU, EV, PV, or E bit at the same time.
Bit 0: P
0
1
Note:
* Do not access flash memory while the E bit is set to 1.
* Do not access flash memory while the P bit is set.
Section 18 ROM (H8/3048F-ONE: Single Power Supply, H8/3048B Mask ROM Version)
Program-verify mode cleared
Transition to program-verify mode
[Setting condition]
When FWE = 1 and SWE = 1
Description
Erase mode cleared
Transition to erase mode *
[Setting condition]
When FWE = 1, SWE = 1, and ESU = 1
Description
Program mode cleared
Transition to program mode *
[Setting condition]
When FWE = 1, SWE = 1, and PSU = 1
Description
Rev. 3.00 Sep 27, 2006 page 587 of 872
REJ09B0325-0300
(Initial value)
(Initial value)
(Initial value)