CS1D-IC102D Omron, CS1D-IC102D Datasheet - Page 466
CS1D-IC102D
Manufacturer Part Number
CS1D-IC102D
Description
CS1D Dual IO Control Unit
Manufacturer
Omron
Datasheet
1.CS1D-SP002.pdf
(638 pages)
Specifications of CS1D-IC102D
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
- Current page: 466 of 638
- Download datasheet (12Mb)
Replacing User-serviceable Parts
!Caution Do not short the battery terminals or charge, disassemble, heat, or incinerate
!Caution Dispose of any battery that has been dropped on the floor or otherwise sub-
!Caution Do not allow unqualified persons to replace batteries. UL standards required
Note
6. Remove the old battery’s connector.
7. Push the new battery’s wire into the battery compartment and close the
8. Connect a Programming Device and verify that the Battery Error has been
1. With CPU Units Ver. 1.2 or later in a Duplex CPU System, even if this pro-
2. If the above procedure is not used and the old battery is disconnected with
3. With CPU Units that have two battery connectors, leave the old battery at-
the battery. Do not subject the battery to strong shocks. Doing any of these
may result in leakage, rupture, heat generation, or ignition of the battery.
jected to excessive shock. Batteries that have been subjected to shock may
leak if they are used.
that batteries be replaced only by experienced technicians.
cover.
cleared.
cedure is not used and the old battery is disconnected with the power OFF
(power OFF and no battery connected), memory will be backed up for a
short time by an internal capacitor. In this case, the internal capacitor will
discharge within approximately 30 s after the power is turned OFF, so be
sure to connect the new battery immediately.
the power ON (power ON and no battery connected), memory will still be
backed up. However, be sure to touch a grounded metal object to dis-
charge any static electricity before replacing the battery.
tached while connecting the new battery. This prevents a battery error oc-
curring during battery replacement. Remove the old battery after the new
battery is connected.
Old battery
Section 11-2
431
Related parts for CS1D-IC102D
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
CS1D Dual IO Interface Unit
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
CS1D Dual CPU Exp
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
CS1D Dual Exp Rack
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
CS1D Dual IO Exp
Manufacturer:
Omron
Datasheet:
Part Number:
Description:
G6S-2GLow Signal Relay
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Compact, Low-cost, SSR Switching 5 to 20 A
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet: