NH82801DB S L8DE Intel, NH82801DB S L8DE Datasheet - Page 415

• Manufacturer Part Number: NH82801DB S L8DE
• Manufacturer: Intel

Specifications of NH82801DB S L8DE

• Lead Free Status / RoHS Status: Compliant

11.2.7
Intel
®
82801DB ICH4 Datasheet
Note: For Function 0, this register applies to ICH4 USB ports 0 and 1; for Function 1, this register applies
PORTSC[0,1]—Port Status and Control Register
I/O Offset:
Default Value:
to ICH4 USB ports 2 and 3; for Function 2, this register applies to ICH4 USB ports 4 and 5.
After a Power-up reset, Global reset, or Host controller reset, the initial conditions of a port are: no
device connected, port disabled, and the bus line status is 00 (single-ended zero).
15:13
Bit
12
10
11
9
8
7
Reserved — RO.
Suspend — R/W This bit should not be written to a 1 if global suspend is active (bit 3=1 in the
USBCMD register). Bit 2 and bit 12 of this register define the hub states as follows:
When in suspend state, downstream propagation of data is blocked on this port, except for single-
ended 0 resets (global reset and port reset). The blocking occurs at the end of the current
transaction, if a transaction was in progress when this bit was written to 1. In the suspend state, the
port is sensitive to resume detection. Note that the bit status does not change until the port is
suspended and that there may be a delay in suspending a port if there is a transaction currently in
progress on the USB.
0 = Port not in suspend state.
1 = Port in suspend state.
NOTE: Normally, if a transaction is in progress when this bit is set, the port will be suspended
Over-current Indicator — R/WC. Set by hardware.
0 = Software clears this bit by writing a 1 to the bit position.
1 = Overcurrent pin has gone from inactive to active on this port.
Over-current Active — RO. This bit is set and cleared by hardware.
0 = Indicates that the overcurrent pin is inactive (high).
1 = Indicates that the overcurrent pin is active (low).
Port Reset — RO
0 = Port is not in Reset.
1 = Port is in Reset. When set, the port is disabled and sends the USB Reset signaling.
Low Speed Device Attached (LS) — RO Writes have no effect.
0 = Full speed device is attached.
1 = Low speed device is attached to this port.
Reserved — RO. Always read as 1.
Bits [12,2]
X0
01
11
when the current transaction completes. However, in the case of a specific error condition
(out transaction with babble), the ICH4 may issue a start-of-frame, and then suspend the
port.
Port 0/2/4: Base + (10
Port 1/3/5: Base + (12
0080h
Hub State
Disable
Enable
Suspend
–
–
11h)Attribute:
13h)
Description
Size:
USB UHCI Controllers Registers
R/WC, RO, R/W (Word writes only)
16 bits
415