NH82801DB S L8DE Intel, NH82801DB S L8DE Datasheet - Page 91

• Manufacturer Part Number: NH82801DB S L8DE
• Manufacturer: Intel

Specifications of NH82801DB S L8DE

• Lead Free Status / RoHS Status: Compliant

5.3.1.9
5.3.1.10
5.3.1.11
5.3.1.12
Intel
®
82801DB ICH4 Datasheet
Note: If the cycle is not claimed by any peripheral (and subsequently aborted), the ICH4 returns a value
Note: The ICH4 does not support LPC Bus Masters performing I/O cycles. LPC Bus Masters should only
Note: The ICH4 cannot accept PCI write cycles from PCI-to-PCI bridges or devices with similar
LPC Power Management
Configuration and Intel
I/O Cycles
For I/O cycles targeting registers specified in the ICH4’s decode ranges, the ICH4 performs I/O
cycles as defined in the LPC specification. These will be 8-bit transfers. If the processor attempts a
16-bit or 32-bit transfer, the ICH4 breaks the cycle up into multiple 8-bit transfers to consecutive
I/O addresses.
of all ones (FFh) to the processor. This is to maintain compatibility with ISA I/O cycles where pull-
up resistors would keep the bus high if no device responds.
Bus Master Cycles
The ICH4 supports Bus Master cycles and requests (using LDRQ#) as defined in the LPC
specification. The ICH4 has two LDRQ# inputs, and thus, supports two separate bus master
devices. It uses the associated START fields for Bus Master 0 (0010b) or Bus Master 1 (0011b).
perform memory read or memory write cycles.
LPCPD# Protocol
Same timings as for SUS_STAT#. Upon driving SUS_STAT# low, LPC peripherals will drive
LDRQ# low or tri-state it. ICH4 will shut off the LDRQ# input buffers. After driving SUS_STAT#
active, the ICH4 drives LFRAME# low, and tri-states (or drive low) LAD[3:0].
LPC Interface Decoders
To allow the I/O cycles and memory mapped cycles to go to the LPC interface, the ICH4 includes
several decoders. During configuration, the ICH4 must be programmed with the same decode ranges
as the peripheral. The decoders are programmed via the Device 31:Function 0 configuration space.
characteristics (specifically those with a “Retry Read” feature which is enabled) to an LPC device
if there is an outstanding LPC read cycle towards the same PCI device or bridge. These cycles are
not part of normal system operation, but may be encountered as part of platform validation testing
using custom test fixtures.
Bus Master Device Mapping and START Fields
Bus Masters must have a unique START field. In the case of the ICH4, which supports 2 LPC bus
masters, it will drive 0010 for the START field for grants to bus master #0 (requested via
LDRQ[0]#) and 0011 for grants to bus master #1 (requested via LDRQ[1]#.). Thus, no registers are
needed to configure the START fields for a particular bus master.
®
ICH4 Implications
Functional Description
91