FW82801EB S L73Z Intel, FW82801EB S L73Z Datasheet - Page 477
FW82801EB S L73Z
Manufacturer Part Number
FW82801EB S L73Z
Description
Manufacturer
Intel
Datasheet
1.FW82801EB_S_L73Z.pdf
(671 pages)
Specifications of FW82801EB S L73Z
Lead Free Status / RoHS Status
Not Compliant
- Current page: 477 of 671
- Download datasheet (8Mb)
12.2.7
Intel
®
82801EB ICH5 / 82801ER ICH5R Datasheet
Note: For Function 0, this applies to ICH5 USB ports 0 and 1; for Function 1, this applies to ICH5 USB
PORTSC[0,1]—Port Status and Control Register
I/O Offset:
Default Value:
ports 2 and 3; for Function 2, this applies to ICH5 USB ports 4 and 5; and for Function 3, this
applies to ICH5 USB ports 6 and 7.
After a Power-up Reset, Global Reset, or Host Controller Reset, the initial conditions of a port are:
no device connected, Port disabled, and the bus line status is 00 (SE0).
15:13
Bit
12
10
11
9
8
7
6
Reserved — RO.
Suspend — R/W. This bit should not be written to a 1 if global suspend is active (bit 3=1 in the
USBCMD register). Bit 2 and bit 12 of this register define the hub states as follows:
When in suspend state, downstream propagation of data is blocked on this port, except for
single-ended 0 resets (global reset and port reset). The blocking occurs at the end of the current
transaction, if a transaction was in progress when this bit was written to 1. In the suspend state, the
port is sensitive to resume detection. Note that the bit status does not change until the port is
suspended and that there may be a delay in suspending a port if there is a transaction currently in
progress on the USB.
1 = Port in suspend state.
0 = Port not in suspend state.
NOTE: Normally, if a transaction is in progress when this bit is set, the port will be suspended when
Overcurrent Indicator — R/WC. Set by hardware.
0 = Software clears this bit by writing a 1 to it.
1 = Overcurrent pin has gone from inactive to active on this port.
Overcurrent Active — RO. This bit is set and cleared by hardware.
0 = Indicates that the overcurrent pin is inactive (high).
1 = Indicates that the overcurrent pin is active (low).
Port Reset — R/W.
0 = Port is not in Reset.
1 = Port is in Reset. When set, the port is disabled and sends the USB Reset signaling.
Low Speed Device Attached (LS) — RO.
0 = Full speed device is attached.
1 = Low speed device is attached to this port.
Reserved — RO. Always read as 1.
Resume Detect (RSM_DET) — R/W. Software sets this bit to a 1 to drive resume signaling. The
host controller sets this bit to a 1 if a J-to-K transition is detected for at least 32 microseconds while
the port is in the Suspend state. The ICH5 will then reflect the K-state back onto the bus as long as
the bit remains a 1, and the port is still in the suspend state (bit 12,2 are ‘11’). Writing a 0 (from 1)
causes the port to send a low speed EOP. This bit will remain a 1 until the EOP has completed.
0 = No resume (K-state) detected/driven on port.
1 = Resume detected/driven on port.
Bits [12,2]
X0
01
11
the current transaction completes. However, in the case of a specific error condition (out
transaction with babble), the Intel
port.
Port 0/2/4/6: Base + (10
Port 1/3/5/7: Base + (12
0080h
Hub State
Disable
Suspend
Enable
–
–
11h)
13h)
®
Description
ICH5 may issue a start-of-frame, and then suspend the
Attribute: R/WC, RO,
Size:
UHCI Controllers Registers
R/W (Word writes only)
16 bits
477
Related parts for FW82801EB S L73Z
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Microprocessor: Intel Celeron M Processor 320 and Ultra Low Voltage Intel Celeron M Processor at 600MHz
Manufacturer:
Intel Corporation
Part Number:
Description:
Intel 82550 Fast Ethernet Multifunction PCI/CardBus Controller
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 120 ns
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 120 ns
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel StrataFlash memory 64 Mbit. Access speed 150 ns
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel StrataFlash memory 32 Mbit. Access speed 100 ns
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
DA28F640J5A-1505 Volt Intel StrataFlash Memory
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
5 Volt Intel StrataFlash?? Memory
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
5 Volt Intel StrataFlash?? Memory
Manufacturer:
Intel Corporation
Part Number:
Description:
Intel 6300ESB I/O Controller Hub
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel 82801DB I/O Controller Hub (ICH4), Pb-Free SLI
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel 82801FB I/O Controller Hub (ICH6)
Manufacturer:
Intel Corporation
Datasheet:
Part Number:
Description:
Intel Strataflash Memory28F128J3 28F640J3 28F320J3
Manufacturer:
Intel Corporation
Datasheet: