SAM7S32 Atmel Corporation, SAM7S32 Datasheet - Page 299

• Manufacturer Part Number: SAM7S32
• Manufacturer: Atmel Corporation

Specifications of SAM7S32

• Flash (kbytes): 32 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 55 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 21
• Ext Interrupts: 21
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Twi (i2c): 1
• Uart: 2
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 8
• Self Program Memory: NO
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

29.6.6
6175L–ATARM–28-Jul-11
Read/Write Flowcharts
The following flowcharts shown in
page
give examples for read and write operations. A polling or interrupt method can be used to check
the status bits. The interrupt method requires that the interrupt enable register (TWI_IER) be
configured first.
Figure 29-13. TWI Write Operation with Single Data Byte without Internal Address
301,
Figure 29-16 on page
(CLDIV, CHDIV, CKDIV) in TWI_CWGR
- Device slave address (DADR)
Set the Master Mode register:
302,
Write ==> bit MREAD = 0
TWI_THR = Data to send
Set the Control register:
Load Transmit register
- Transfer direction bit
Read Status register
Read Status register
Figure
(Needed only once)
TWI_CR = MSEN
Transfer finished
- Master enable
TXCOMP = 1?
Set TWI clock
Figure 29-17 on page 303
TXRDY = 1?
Yes
Yes
BEGIN
29-13,
Figure 29-14 on page
No
No
and
SAM7S Series
Figure 29-18 on page 304
300,
Figure 29-15 on
299