SAM9XE512 Atmel Corporation, SAM9XE512 Datasheet - Page 682

• Manufacturer Part Number: SAM9XE512
• Manufacturer: Atmel Corporation

Specifications of SAM9XE512

• Flash (kbytes): 512 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 180 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 6
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 312
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.65 to 1.95
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

38.5.5
Register Name:
Address:
Access Type:
This register points to the entry in the receive buffer queue (descriptor list) currently being used. It is written with the start
location of the receive buffer descriptor list. The lower order bits increment as buffers are used up and wrap to their original
values after either 1024 buffers or when the wrap bit of the entry is set.
Reading this register returns the location of the descriptor currently being accessed. This value increments as buffers are
used. Software should not use this register for determining where to remove received frames from the queue as it con-
stantly changes as new frames are received. Software should instead work its way through the buffer descriptor queue
checking the used bits.
Receive buffer writes also comprise bursts of two words and, as with transmit buffer reads, it is recommended that bit 2 is
always written with zero to prevent a burst crossing a 1K boundary, in violation of section 3.6 of the AMBA specification.
• ADDR:
Written with the address of the start of the receive queue, reads as a pointer to the current buffer being used.
682
31
23
15
7
AT91SAM9XE128/256/512 Preliminary
Receive buffer queue pointer address
Receive Buffer Queue Pointer Register
30
22
14
EMAC_RBQP
0xFFFC4018
Read-write
6
29
21
13
5
ADDR
28
20
12
4
ADDR
ADDR
ADDR
27
19
11
3
26
18
10
2
25
17
9
1
–
6254C–ATARM–22-Jan-10
24
16
8
0
–