SAM9XE512 Atmel Corporation, SAM9XE512 Datasheet - Page 720

• Manufacturer Part Number: SAM9XE512
• Manufacturer: Atmel Corporation

Specifications of SAM9XE512

• Flash (kbytes): 512 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 180 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 6
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 312
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.65 to 1.95
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

720
AT91SAM9XE128/256/512 Preliminary
When a setup transaction is received after a stall handshake, STALLSENT must be cleared in
order to prevent interrupts due to STALLSENT being set.
Figure 39-12. Stall Handshake (Data IN Transfer)
Figure 39-13. Stall Handshake (Data OUT Transfer)
1. The microcontroller sets the FORCESTALL flag in the UDP_CSRx endpoint’s register.
2. The host receives the stall packet.
3. The microcontroller is notified that the device has sent the stall by polling the
USB Bus
Packets
FORCESTALL
STALLSENT
USB Bus
Packets
FORCESTALL
STALLSENT
STALLSENT to be set. An endpoint interrupt is pending while STALLSENT is set. The
microcontroller must clear STALLSENT to clear the interrupt.
Data OUT PID
Data IN
PID
Set by USB Device
Data OUT
Stall PID
Set by Firmware
Stall PID
Set by Firmware
Interrupt Pending
Interrupt Pending
Set by
USB Device
Cleared by Firmware
Cleared by Firmware
Cleared by Firmware
6254C–ATARM–22-Jan-10