upd78f0730 Renesas Electronics Corporation., upd78f0730 Datasheet - Page 24

• Manufacturer Part Number: upd78f0730
• Description: 8-bit Single-chip Microcontroller
• Manufacturer: Renesas Electronics Corporation.

2.2.3 P30 to P33 (port 3)
timer I/O.
(1) Port mode
(2) Control mode
2.2.4 P60 and P61 (port 6)
(1) Port mode
24
P30 to P33 function as a 4-bit I/O port. These pins also function as pins for external interrupt request input and
The following operation modes can be specified in 1-bit units.
P60 and P61 function as a 2-bit I/O port.
The following operation modes can be specified in 1-bit units.
Cautions 1. In the
Remark Only for the
P30 to P33 function as a 4-bit I/O port. P30 to P33 can be set to input or output port in 1-bit units using port
mode register 3 (PM3). Use of an on-chip pull-up resistor can be specified by pull-up resistor option register 3
(PU3).
P30 to P33 function as external interrupt request input and timer I/O.
(a) INTP1 to INTP3
(b) TI51
(c) TO51
P60 and P61 function as a 2-bit I/O port. P60 and P61 can be set to input port or output port in 1-bit units using
port mode register 6 (PM6).
Output of P60 and P61 is N-ch open-drain output (6 V tolerance).
These are the external interrupt request input pins for which the valid edge (rising edge, falling edge, or both
rising and falling edges) can be specified.
This is an external count clock input pin to 8-bit timer/event counter 51.
This is a timer output pin from 8-bit timer/event counter 51.
2. When writing the flash memory with a flash memory programmer, connect P31/INTP2/OCD1A as
OCD1B) when the on-chip debug function is used. For how to connect an in-circuit emulator supporting
on-chip debugging (QB-78K0MINI), see CHAPTER 22 ON-CHIP DEBUG FUNCTION.
malfunction.
follows.
• P31/INTP2/OCD1A: Connect to EV
The above connection is not necessary when writing the flash memory by means of self
programming.
µ
PD78F0730, be sure to pull the P31 pin down before a reset release to prevent
µ
PD78F0730, P31 and P32 can be used as on-chip debug mode setting pins (OCD1A,
Preliminary User’s Manual U19014EJ1V0UD
CHAPTER 2 PIN FUNCTIONS
SS
via a resistor (10 kΩ: recommended).