hd64338023s Renesas Electronics Corporation., hd64338023s Datasheet - Page 430

• Manufacturer Part Number: hd64338023s
• Description: Renesas 8-bit Single-chip Microcomputer Super Low Power Series
• Manufacturer: Renesas Electronics Corporation.

Section 10 Serial Communication Interface
8. Transmit and receive operations when making a state transition
Make sure that transmit and receive operations have completely finished before carrying out state
transition processing.
9. Switching SCK
If pin SCK
general input/output pin (a pin with a different function), the pin outputs a low level signal for half
a system clock (φ) cycle immediately after it is switched.
This can be prevented by either of the following methods according to the situation.
a. When an SCK
b. When an SCK
10. Set up at subactive or subsleep mode
At subactive or subsleep mode, SCI3 becomes possible use only at CPU clock is φw/2.
11. Oscillator use with serial communications interface (H8/38124 Group only)
When implementing the serial communications interface on the H8/38124 Group, the system
clock oscillator must be used. The on-chip oscillator should not be used in this case. See 4.2 (5),
on-chip oscillator selection method, for information on switching between the system clock
oscillator and the on-chip oscillator.
Rev. 7.00 Mar 10, 2005 page 388 of 652
REJ09B0042-0700
When stopping data transfer, issue one instruction to clear bits TE and RE to 0 and to set bits
CKE1 and CKE0 in SCR3 to 1 and 0, respectively. In this case, bit COM in SMR should be
left 1. The above prevents SCK
intermediate level of voltage from being applied to SCK
be pulled up to the V
When stopping data transfer,
(i) Issue one instruction to clear bits TE and RE to 0 and to set bits CKE1 and CKE0 in SCR3
(ii) Clear bit COM in SMR to 0
(iii) Clear bits CKE1 and CKE0 in SCR3 to 0
Note that special care is also needed here to avoid an intermediate level of voltage from being
applied to SCK
to 1 and 0, respectively.
32
is used as a clock output pin by SCI3 in synchronous mode and is then switched to a
32
32
32
32
function is switched from clock output to non clock-output
function is switched from clock output to general input/output
.
function
CC
level via a resistor, or supplied with output from an external device.
32
from being used as a general input/output pin. To avoid an
32
, the line connected to SCK
32
should