mc9s12xf512 Freescale Semiconductor, Inc, mc9s12xf512 Datasheet - Page 334

• Manufacturer Part Number: mc9s12xf512
• Description: S12x Microcontrollers 16-bit Automotive Microcontroller
• Manufacturer: Freescale Semiconductor, Inc

Chapter 9 512 KByte Flash Module (S12XFTM512K3V1)
9.4.2.19
The Enable EEPROM Emulation command causes the Memory Controller to enable EEE activity. EEE
activity is disabled after any reset.
Upon clearing CCIF to launch the Enable EEPROM Emulation command, the CCIF flag will set after the
Memory Controller enables EEE operations using the contents of the EEE tag RAM and tag counter. The
Full Partition D-Flash or the Partition D-Flash command must be run prior to launching the Enable
EEPROM Emulation command.
334
FERSTAT
FERSTAT
Register
Register
FSTAT
FSTAT
Enable EEPROM Emulation Command
Table 9-71. Enable EEPROM Emulation Command FCCOB Requirements
Table 9-72. Enable EEPROM Emulation Command Error Handling
CCOBIX[2:0]
MGSTAT1
MGSTAT0
EPVIOLIF
MGSTAT1
MGSTAT0
EPVIOLIF
ACCERR
ACCERR
Error Bit
Error Bit
FPVIOL
FPVIOL
Table 9-70. Erase D-Flash Sector Command Error Handling
000
MC9S12XF - Family Reference Manual, Rev.1.19
Set if CCOBIX[2:0] != 001 at command launch
Set if a Load Data Field command sequence is currently active
Set if command not available in current mode (see
Set if an invalid global address [22:0] is supplied
Set if a misaligned word address is supplied (global address [0] != 0)
Set if the global address [22:0] points to the D-Flash EEE partition
None
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
None
Set if CCOBIX[2:0] != 000 at command launch
Set if a Load Data Field command sequence is currently active
Set if Full Partition D-Flash or Partition D-Flash command not previously run
None
None
None
None
0x13
FCCOB Parameters
Error Condition
Error Condition
Not required
Table
9-30)
Freescale Semiconductor