XCS05XL Xilinx, XCS05XL Datasheet - Page 21

• Manufacturer Part Number: XCS05XL
• Description: Spartan and Spartan-XL Families Field Programmable Gate Arrays
• Manufacturer: Xilinx

Figure 20
logic. It includes three bits of Data Register per IOB, the
IEEE 1149.1 Test Access Port controller, and the Instruction
Register with decodes.
Spartan/XL devices can also be configured through the
boundary scan logic. See
Boundary Scan Pins, page
Data Registers
The primary data register is the boundary scan register. For
each IOB pin in the FPGA, bonded or not, it includes three
bits for In, Out and 3-state Control. Non-IOB pins have
appropriate partial bit population for In or Out only. PRO-
GRAM, CCLK and DONE are not included in the boundary
scan register. Each EXTEST CAPTURE-DR state captures
all In, Out, and 3-state pins.
The data register also includes the following non-pin bits:
TDO.T, and TDO.O, which are always bits 0 and 1 of the
data register, respectively, and BSCANT.UPD, which is
always the last bit of the data register. These three bound-
ary scan bits are special-purpose Xilinx test signals.
DS060 (v1.6) September 19, 2001
Product Specification
is a diagram of the Spartan/XL boundary scan
R
37.
Configuration Through the
Spartan and Spartan-XL Families Field Programmable Gate Arrays
www.xilinx.com
1-800-255-7778
The other standard data register is the single flip-flop
BYPASS register. It synchronizes data being passed
through the FPGA to the next downstream boundary scan
device.
The FPGA provides two additional data registers that can
be specified using the BSCAN macro. The FPGA provides
two user pins (BSCAN.SEL1 and BSCAN.SEL2) which are
the decodes of two user instructions. For these instructions,
two corresponding pins (BSCAN.TDO1 and BSCAN.TDO2)
allow user scan data to be shifted out on TDO. The data
register clock (BSCAN.DRCK) is available for control of test
logic which the user may wish to implement with CLBs. The
NAND of TCK and RUN-TEST-IDLE is also provided
(BSCAN.IDLE).
Instruction Set
The Spartan/XL boundary scan instruction set also includes
instructions to configure the device and read back the con-
figuration data. The instruction set is coded as shown in
Table
12.
21