ENC28J60-C/ML MICROCHIP [Microchip Technology], ENC28J60-C/ML Datasheet - Page 33
ENC28J60-C/ML
Manufacturer Part Number
ENC28J60-C/ML
Description
Stand-Alone Ethernet Controller with SPI Interface
Manufacturer
MICROCHIP [Microchip Technology]
Datasheet
1.ENC28J60-CML.pdf
(96 pages)
- Current page: 33 of 96
- Download datasheet (2Mb)
5.0
Before discussing the use of the ENC28J60 as an
Ethernet interface, it may be helpful to review the
structure of a typical data frame. Users requiring more
information should refer to IEEE Standard 802.3 which
is the basis for the Ethernet protocol.
5.1
Normal IEEE 802.3 compliant Ethernet frames are
between 64 and 1518 bytes long. They are made up of
five or six different fields: a destination MAC address, a
source MAC address, a type/length field, data payload,
an optional padding field and a Cyclic Redundancy
Check (CRC). Additionally, when transmitted on the
Ethernet medium, a 7-byte preamble field and start-of-
frame delimiter byte are appended to the beginning of
the Ethernet packet. Thus, traffic seen on the twisted
pair cabling will appear as shown in Figure 5-1.
FIGURE 5-1:
© 2006 Microchip Technology Inc.
Note 1: The FCS is transmitted starting with bit 31 and ending with bit 0.
Used in the
Calculation
of the FCS
ETHERNET OVERVIEW
Packet Format
ETHERNET PACKET FORMAT
46-1500
of Bytes
Number
7
1
6
6
2
4
Type/Length
Preamble
Padding
FCS
Field
Data
SFD
DA
SA
(1)
Preliminary
5.1.1
When transmitting and receiving data with the
ENC28J60, the preamble and start of frame delimiter
bytes will automatically be generated or stripped from
the packets when they are transmitted or received. The
host controller does not need to concern itself with
them. Normally, the host controller will also not need to
concern itself with padding and the CRC which the
ENC28J60 will also be able to automatically generate
when transmitting and verify when receiving. The
padding and CRC fields will, however, be written into
the receive buffer when packets arrive, so they may be
evaluated by the host controller if needed.
Filtered out by the Module
Start-of-Frame Delimiter
(filtered out by the module)
Destination Address,
such as Multicast, Broadcast or Unicast
Source Address
Type of Packet or the Length of the Packet
Packet Payload
(with optional padding)
Frame Check Sequence – CRC
PREAMBLE/START-OF-FRAME
DELIMITER
Comments
ENC28J60
DS39662B-page 31
Related parts for ENC28J60-C/ML
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
IC ETHERNET CTRL 8K W/SPI 28SSOP
Manufacturer:
Microchip Technology
Datasheet:
Part Number:
Description:
IC ETHERNET CTRLR W/SPI 28QFN
Manufacturer:
Microchip Technology
Datasheet:
Part Number:
Description:
IC ETHERNET CTRLR W/SPI 28DIP
Manufacturer:
Microchip Technology
Datasheet:
Part Number:
Description:
IC ETHERNET CTRLR W/SPI 28SOIC
Manufacturer:
Microchip Technology
Datasheet:
Part Number:
Description:
IC ETHERNET CTRLR W/SPI 28SSOP
Manufacturer:
Microchip Technology
Datasheet:
Part Number:
Description:
IC ETHERNET CTRLR W/SPI 28QFN
Manufacturer:
Microchip Technology
Datasheet:
Part Number:
Description:
IC ETHERNET CTRLR W/SPI 28SOIC
Manufacturer:
Microchip Technology
Datasheet:
Part Number:
Description:
IC ETHERNET CTRLR W/SPI 28DIP
Manufacturer:
Microchip Technology
Datasheet:
Part Number:
Description:
Stand-alone Ethernet Controller With Spi Interface
Manufacturer:
Microchip Technology Inc.
Datasheet:
Part Number:
Description:
Ethernet Modules ETHERNET TYPE ENC28 GADGETEER MODULE
Manufacturer:
GHI Electronics
Part Number:
Description:
28/40/44-Pin Enhanced Flash Microcontrollers with ECAN Technology, 10-Bit A/D and nanoWatt Technology
Manufacturer:
MICROCHIP [Microchip Technology]
Datasheet:
Part Number:
Description:
28/40/44-Pin Enhanced Flash Microcontrollers with ECAN Technology, 10-Bit A/D and nanoWatt Technology
Manufacturer:
MICROCHIP [Microchip Technology]
Datasheet:
Part Number:
Description:
Low-Cost NV Digital POT with WiperLock™ Technology
Manufacturer:
MICROCHIP [Microchip Technology]
Datasheet: