THNCF512MDG Toshiba, THNCF512MDG Datasheet - Page 43

• Manufacturer Part Number: THNCF512MDG
• Description: MEMORY CARD COMPACT FLASH 512MB
• Manufacturer: Toshiba

Specifications of THNCF512MDG

• Memory Size: 512MB
• Memory Type: CompactFLASH
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Package Dimensions
Attention for Card Use
•
•
•
•
•
•
•
(.130 in ± .004)
3.30mm ± .10
In the reset or power off, the information of all registers is cleared.
Notice that the card insertion/removal should not be executed during host is active, if the card is used in True
IDE mode.
After the card hard reset, soft reset, or power on reset, ATA reset, command applied the card cannot access
during READY pin is “low” level. Flash card can’t be operated in this case.
Before the card insertion V
inseted, supply V
−OE must be kept at the V
kept constantly at the GND level in True IDE mode.
Do not turn off the power or remove THNCFxxxxDG Series from the slot before read/write operation is complete.
Avoid using THNCFxxxxDG Series when the battery is low. Power shortage, power failure and/or removal of
THNCFxxxxDG Series from the slot before read/write operation is complete may cause malfunction of
THNCFxxxxDG Series, data loss and/or damage to data.
Routine performance of backing-up data (or taking back-up of data) is strongly recommended.
4xR 0.5mm ± .1
(4xR.020 in ± .004)
(.063 in ± .002)
1.60mm ± .05
Note:
CC
to the card.
.01mm ± .07(.039 in ± .003)
The optional notched configuration was shown in the CF Specification Rev.1.0. In
Specification Rev. 1.2. The notch was removed for ease of tooling.
This optional configuration can be used but it is not recommended.
Type Ⅰ CompactFlash Storage Card Dimensions
CC
26
1
CC
level during power on reset in memory card mode and I/O card mode. −OE must be
41.66mm ± .13(1.640 in ±. 005)
cannot be supplied to the card. After confirmation that −CD1, −CD2 pins are
42.80mm ± .10(1.685 in ± .004)
TOP
TENTATIVE
.01mm ± .07(.039 in ± .003)
50
25
0.63mm ± .07(.025 in ± .003)
.99mm ± .05
(.039 in ± .002)
THNCFxxxxDG Series
0.76mm ± .07(0.30 in ± .003)
(.085 in x .003)
2.15mm ± .07
2004-05-18 43/44
Optional Configuration
(See Note)
2.44mm ± .07
(.096 in ± .003)