MC56F8037EVM Freescale Semiconductor, MC56F8037EVM Datasheet - Page 2

• Manufacturer Part Number: MC56F8037EVM
• Description: BOARD EVAL FOR MC56F8037
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of MC56F8037EVM

• Contents: Board, Cables, CD, Debugger
• Silicon Manufacturer: Freescale
• Core Architecture: 56800/E
• Core Sub-architecture: 56800/E
• Silicon Core Number: MC56F
• Silicon Family Name: MC56F80xx
• Kit Contents: MC56F8037EVM, USB-JTAG Adapter, Cables, CD
• Rohs Compliant: Yes
• For Use With/related Products: MC56F8037
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2
Rev. 0
Rev. 1
Rev. 2
Rev. 3
Rev. 4
Rev. 5
Version History
Initial public release.
• In Table 10-4, added an entry for flash data retention with less than 100 program/erase
• In Table 10-6, changed the device clock speed in STOP mode from 8MHz to 4MHz.
• In Table 10-12, changed the typical relaxation oscillator output frequency in Standby mode
• Changed input propagation delay values in Table 10-21 as follows:
In Table 10-20, changed the maximum ADC internal clock frequency from 8MHz to 5.33MHz.
• Added the following note to the description of the TMS signal in Table 2-3:
Note:
• Changed the description of the GPIOC4 signal in Table 2-3 (was “...the signal goes to both
• Changed the ITCN_BASE address In
• In
• Changed the STANDBY > STOP I
• Changed the POWERDOWN I
• Changed footnote 1 in
• Deleted the text “at 125°C” from
• Changed the maximum input offset voltage in
• In
• Revised
• Added information for 56F8027 device throughout document.
• Fixed miscellaneous typos.
cycles (minimum 20 years).
from 400kHz to 200kHz.
the ANA0 and CMPAI3”, is “...the signal goes to both ANB0 and CMPB13”).
value, at 125°C.”, is “Output frequency after application of factory trim”).
Figure
Table
Always tie the TMS pin to V
Section 7, Security
2-3, changed V
5-10, moved the footnote marker (superscript 1) from bit 4 to “RESET”.
56F8037/56F8027 Data Sheet, Rev. 7
Document Revision History
New values: 35 ns typical, 45 ns maximum
Table 10-12
Old values: 1 s typical, 2 s maximum
CAP
Maximum: was 390A, is 650A
Maximum: was 250A, is 550A
value from 4.7F to 2.2F.
Typical: was 290A, is 540A
Typical: was 190A, is 440A
Features.
DD
DD
Description of Change
Figure
values in
DD
through a 2.2K resistor.
(was “Output frequency after application of 8MHz trim
values in
Table 5-3
10-5.
Table 10-6
Table 10-21
Table 10-6
(was $00 F060, is $00 F0E0).
as follows:
as follows:
(was +/- 20 mV, is ±35 mV).
Freescale Semiconductor