S25FL016K0XMFI011 Spansion Inc., S25FL016K0XMFI011 Datasheet - Page 44

• Manufacturer Part Number: S25FL016K0XMFI011
• Description: MEMORY, FLASH, 16M, 3V, SPI, 8SOIC
• Manufacturer: Spansion Inc.

Specifications of S25FL016K0XMFI011

• Memory Size: 16Mbit
• Clock Frequency: 104MHz
• Supply Voltage Range: 2.7V To 3.6V
• Memory Case Style: SO
• No. Of Pins: 8
• Operating Temperature Range: -40°C To +85°C
• Interface: SPI
• Memory Type: RoHS Compliant
• Memory Configuration: 8K X 256 Bytes
• Interface Type: SPI
• Rohs Compliant: Yes

7.24
44
Erase / Program Resume (7Ah)
The Erase/Program Resume instruction “7Ah” must be written to resume the Sector or Block Erase operation
or the Page Program operation after an Erase/Program Suspend. The Resume instruction “7Ah” will be
accepted by the device only if the SUS bit in the Status Register equals to 1 and the BUSY bit equals to 0.
After issued the SUS bit will be cleared from 1 to 0 immediately, the BUSY bit will be set from 0 to 1 within
200 ns and the Sector or Block will complete the erase operation or the page will complete the program
operation. If the SUS bit equals to 0 or the BUSY bit equals to 1, the Resume instruction “7Ah” will be ignored
by the device. The Erase/Program Resume instruction sequence is shown in
Resume instruction is ignored if the previous Erase/Program Suspend operation was interrupted by
unexpected power off. It is also required that a subsequent Erase/Program Suspend instruction not to be
issued within a minimum of time of “t
CLK
CS#
SI
Mode 3
Mode 0
0
1
Figure 7.27 Erase/Program Resume Instruction Sequence
Instruction (7Ah)
2
D a t a
3
SUS
4
S25FL016K
” following a previous Resume instruction.
S h e e t
5
6
7
( P r e l i m i n a r y )
S25FL016K_00_02 September 8, 2010
Figure
Mode 3
Mode 0
Resume Sector or Block Erase
7.27.