LPC1758FBD80 NXP Semiconductors, LPC1758FBD80 Datasheet - Page 22

• Manufacturer Part Number: LPC1758FBD80
• Description: IC, 32BIT MCU, ARM CORTEX, 100MHZ LQFP80
• Manufacturer: NXP Semiconductors

Specifications of LPC1758FBD80

• Controller Family/series: (ARM Cortex)
• No. Of I/o's: 52
• Ram Memory Size: 64KB
• Cpu Speed: 100MHz
• No. Of Timers: 4
• Interface: CAN, I2C, SPI, UART
• Core Size: 32 Bit
• Program Memory Size: 512KB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

NXP Semiconductors
LPC1758_56_54_52_51_3
Product data sheet
7.16.1 Features
7.17.1 Features
7.16 UARTs
7.17 SPI serial I/O controller
7.18 SSP serial I/O controller
The LPC1758/56/54/52/51 each contain four UARTs. In addition to standard transmit and
receive data lines, UART1 also provides a full modem control handshake interface and
support for RS-485/9-bit mode allowing both software address detection and automatic
address detection using 9-bit mode.
The UARTs include a fractional baud rate generator. Standard baud rates such as
115 200 Bd can be achieved with any crystal frequency above 2 MHz.
The LPC1758/56/54/52/51 contain one SPI controller. SPI is a full duplex serial interface
designed to handle multiple masters and slaves connected to a given bus. Only a single
master and a single slave can communicate on the interface during a given data transfer.
During a data transfer the master always sends 8 bits to 16 bits of data to the slave, and
the slave always sends 8 bits to 16 bits of data to the master.
The LPC1758/56/54/52/51 contain two SSP controllers. The SSP controller is capable of
operation on a SPI, 4-wire SSI, or Microwire bus. It can interact with multiple masters and
slaves on the bus. Only a single master and a single slave can communicate on the bus
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Maximum UART data bit rate of 6.25 MBit/s.
16 B Receive and Transmit FIFOs.
Register locations conform to 16C550 industry standard.
Receiver FIFO trigger points at 1 B, 4 B, 8 B, and 14 B.
Built-in fractional baud rate generator covering wide range of baud rates without a
need for external crystals of particular values.
Fractional divider for baud rate control, auto baud capabilities and FIFO control
mechanism that enables software flow control implementation.
UART1 equipped with standard modem interface signals. This module also provides
full support for hardware flow control (auto-CTS/RTS).
Support for RS-485/9-bit/EIA-485 mode (UART1).
UART3 includes an IrDA mode to support infrared communication.
All UARTs have DMA support.
Maximum SPI data bit rate of 12.5 Mbit/s
Compliant with SPI specification
Synchronous, serial, full duplex communication
Combined SPI master and slave
Maximum data bit rate of one eighth of the input clock rate
8 bits to 16 bits per transfer
Rev. 03 — 19 November 2009
LPC1758/56/54/52/51
32-bit ARM Cortex-M3 microcontroller
© NXP B.V. 2009. All rights reserved.
22 of 64