LM3S6950 Luminary Micro, Inc, LM3S6950 Datasheet - Page 36

• Manufacturer Part Number: LM3S6950
• Description: Lm3s6950 Arm Microcontroller
• Manufacturer: Luminary Micro, Inc

Architectural Overview
1.4.4.4
1.4.5
1.4.5.1
1.4.5.2
36
The LM3S6950 controller includes one I
IC devices over an I
and read) data.
Devices on the I
both sending and receiving data as either a master or a slave, and also supports the simultaneous
operation as both a master and a slave. The four I
Slave Transmit, and Slave Receive.
A Stellaris
Both the I
a transmit or receive operation completes (or aborts due to an error). The I
interrupts when data has been sent or requested by a master.
Ethernet Controller (see page 382)
Ethernet is a frame-based computer networking technology for local area networks (LANs). Ethernet
has been standardized as IEEE 802.3. It defines a number of wiring and signaling standards for the
physical layer, two means of network access at the Media Access Control (MAC)/Data Link Layer,
and a common addressing format.
The Stellaris® Ethernet Controller consists of a fully integrated media access controller (MAC) and
network physical (PHY) interface device. The Ethernet Controller conforms to IEEE 802.3
specifications and fully supports 10BASE-T and 100BASE-TX standards. In addition, the Ethernet
Controller supports automatic MDI/MDI-X cross-over correction.
System Peripherals
Programmable GPIOs (see page 169)
General-purpose input/output (GPIO) pins offer flexibility for a variety of connections.
The Stellaris
an individual GPIO port. The GPIO module is FiRM-compliant (compliant to the ARM Foundation
IP for Real-Time Microcontrollers specification) and supports 1-46 programmable input/output pins.
The number of GPIOs available depends on the peripherals being used (see “Signal Tables” on page
495 for the signals available to each GPIO pin).
The GPIO module features programmable interrupt generation as either edge-triggered or
level-sensitive on all pins, programmable control for GPIO pad configuration, and bit masking in
both read and write operations through address lines. Pins configured as digital inputs are
Schmitt-triggered.
Four Programmable Timers (see page 210)
Programmable timers can be used to count or time external events that drive the Timer input pins.
The Stellaris
block provides two 16-bit timers/counters that can be configured to operate independently as timers
or event counters, or configured to operate as one 32-bit timer or one 32-bit Real-Time Clock (RTC).
When configured in 32-bit mode, a timer can run as a Real-Time Clock (RTC), one-shot timer or
periodic timer. When in 16-bit mode, a timer can run as a one-shot timer or periodic timer, and can
extend its precision by using an 8-bit prescaler. A 16-bit timer can also be configured for event
capture or Pulse Width Modulation (PWM) generation.
2
®
C master and slave can generate interrupts. The I
I
®
®
2
C module can operate at two speeds: Standard (100 Kbps) and Fast (400 Kbps).
GPIO module is comprised of seven physical GPIO blocks, each corresponding to
General-Purpose Timer Module (GPTM) contains four GPTM blocks. Each GPTM
2
C bus can be designated as either a master or a slave. The I
2
C bus. The I
2
C bus supports devices that can both transmit and receive (write
Preliminary
2
C module that provides the ability to communicate to other
2
C modes are: Master Transmit, Master Receive,
2
C master generates interrupts when
2
C slave generates
2
C module supports
July 25, 2008