ppc405exr Applied Micro Circuits Corporation (AMCC), ppc405exr Datasheet - Page 9

• Manufacturer Part Number: ppc405exr
• Description: Powerpc 405exr Embedded Processor
• Manufacturer: Applied Micro Circuits Corporation (AMCC)

PPC405EXr – PowerPC 405EXr Embedded Processor
PowerPC 405 Processor
The PPC405 processor is a fixed-point, 32-bit RISC unit.
Features include:
Internal Buses
The PPC405EXr contains four internal buses: the processor local bus (PLB), the Advanced High-Performance Bus
(AHB), the on-chip peripheral bus (OPB), and the device control register (DCR) bus. High performance devices
such as the processor, the DDR SDRAM memory controller, PCI Express, the Ethernet MAL, and DMA utilize the
PLB. Lower bandwidth I/O interfaces such as communications and timer interfaces utilize the OPB. The daisy-
chained DCR bus provides a lower bandwidth path for passing status and control information between the
processor and the other on-chip peripheral functions.
PLB
The Processor Local Bus (PLB) is a high-performance on-chip bus used to connect PLB-equipped master and
slave devices to the PPC405 CPU. It provides a 128-bit data path with 64-bit addressing and operates up to
200MHz. There are bridges between the PLB and the OPB.
Features include:
AHB
The Advanced High-Performance Bus (AHB) is dedicated to the USB OTG 2.0.
Features include:
AMCC Proprietary
• Five-stage pipeline with single-cycle execution of most instructions, including loads and stores
• Separate, configurable 16 KB D- and I-caches, both two-way set associative
• Thirty-two 32-bit general purpose registers (GPRs)
• Unaligned load/store support
• Hardware multiply/divide
• Parity detection and reporting for the instruction cache, data cache, and translation look-aside buffer (TLB)
• Double word instruction fetch from cache
• Translation of the four GB logical address space into physical addresses
• Built-in timer and debug support
• Power management
• DCR interface is 32 bits wide
• Selectable processor vs. bus clock ratios (N:1 ratio only, where N =1, 2, 3,or 4 )
• Separate and simultaneous 6.4GB/s read and write data paths
• Decoupled address and data buses
• Address pipelining
• Late master request abort capability
• Hidden (overlapped) bus request/grant protocol
• Bus arbitration-locking mechanism
• Byte-enable capability allows for unaligned half word transfers and 3-B transfers
• Support for 32- and 64-B burst transfers
• Read word address capability
• Sequential burst protocol
• Guarded and unguarded memory transfers
• Simultaneous control, address, and data phases
• DMA buffered, flyby, peripheral-to-memory, memory-to-peripheral, and DMA memory-to-memory operations
• 32-bit data path
• 32-bit address
• Synchronous to the PLB
• From 60MHz to 100MHz.
Preliminary Data Sheet
Revision 1.10 - July 10, 2008
9