S9S12G96F0MLF Freescale Semiconductor, S9S12G96F0MLF Datasheet - Page 687

• Manufacturer Part Number: S9S12G96F0MLF
• Description: 16-bit Microcontrollers - MCU 16BIT 96K FLASH
• Manufacturer: Freescale Semiconductor

Specifications of S9S12G96F0MLF

• Rohs: yes
• Core: S12
• Processor Series: MC9S12G
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 25 MHz
• Program Memory Size: 96 KB
• Data Ram Size: 8192 B
• On-chip Adc: Yes
• Operating Supply Voltage: 3.13 V to 5.5 V
• Operating Temperature Range: - 40 C to + 125 C
• Package / Case: LQFP-48
• Mounting Style: SMD/SMT

Figure 20-17
while in RXD_2 the break starts in the middle of a transmission. If BRKDFE = 1, in RXD_1 case there
will be no byte transferred to the receive buffer and the RDRF flag will not be modified. Also no framing
error or parity error will be flagged from this transfer. In RXD_2 case, however the break signal starts later
during the transmission. At the expected stop bit position the byte received so far will be transferred to the
receive buffer, the receive data register full flag will be set, a framing error and if enabled and appropriate
a parity error will be set. Once the break is detected the BRKDIF flag will be set.
20.4.5.4
An idle character (or preamble) contains all logic 1s and has no start, stop, or parity bit. Idle character
length depends on the M bit in SCI control register 1 (SCICR1). The preamble is a synchronizing idle
character that begins the first transmission initiated after writing the TE bit from 0 to 1.
If the TE bit is cleared during a transmission, the TXD pin becomes idle after completion of the
transmission in progress. Clearing and then setting the TE bit during a transmission queues an idle
character to be sent after the frame currently being transmitted.
Freescale Semiconductor
Zero Bit Counter
RXD_1
RXD_2
Idle Characters
shows two cases of break detect. In trace RXD_1 the break symbol starts with the start bit,
When queueing an idle character, return the TE bit to logic 1 before the stop
bit of the current frame shifts out through the TXD pin. Setting TE after the
stop bit appears on TXD causes data previously written to the SCI data
register to be lost. Toggle the TE bit for a queued idle character while the
TDRE flag is set and immediately before writing the next byte to the SCI
data register.
If the TE bit is clear and the transmission is complete, the SCI is not the
master of the TXD pin
Start Bit Position
1
2
Figure 20-17. Break Detection if BRKDFE = 1 (M = 0)
3
MC9S12G Family Reference Manual, Rev.1.23
4
Zero Bit Counter
5
6
7
8
NOTE
1
9
Stop Bit Position
2
10
FE = 1
3
BRKDIF = 1
. . .
4
5
6
Serial Communication Interface (S12SCIV5)
7
8
9
10
BRKDIF = 1
. . .
689