ST72T311J2T6 STMicroelectronics, ST72T311J2T6 Datasheet - Page 73

• Manufacturer Part Number: ST72T311J2T6
• Description: 8-bit Microcontrollers - MCU OTP EPROM 8K SPI/I2C
• Manufacturer: STMicroelectronics

Specifications of ST72T311J2T6

• Core: ST7
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 8 MHz
• Program Memory Size: 8 KB
• Data Ram Size: 384 B
• On-chip Adc: Yes
• Operating Supply Voltage: 3 V to 5.5 V
• Package / Case: TQFP-44
• Mounting Style: SMD/SMT
• A/d Bit Size: 8 bit
• A/d Channels Available: 6
• Interface Type: SCI, SPI
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Number Of Programmable I/os: 44
• Number Of Timers: 2
• On-chip Dac: No
• Program Memory Type: OTP EPROM
• Factory Pack Quantity: 160
• Supply Voltage - Max: 5.5 V
• Supply Voltage - Min: 3 V

SERIAL PERIPHERAL INTERFACE (Cont’d)
5.5.4.7 Single Master and Multimaster Configurations
There are two types of SPI systems:
– Single Master System
– Multimaster System
Single Master System
A typical single master system may be configured,
using an MCU as the master and four MCUs as
slaves (see
The master device selects the individual slave de-
vices by using four pins of a parallel port to control
the four SS pins of the slave devices.
The SS pins are pulled high during reset since the
master device ports will be forced to be inputs at
that time, thus disabling the slave devices.
Note: To prevent a bus conflict on the MISO line
the master allows only one active slave device
during a transmission.
Figure 42. Single Master Configuration
5V
Figure
MOSI
SCK
SS
SCK
MOSI
Master
MCU
Slave
MCU
6).
MISO
MISO
SS
MOSI
SCK
Slave
MCU
MISO
SS
For more security, the slave device may respond
to the master with the received data byte. Then the
master will receive the previous byte back from the
slave device if all MISO and MOSI pins are con-
nected and the slave has not written its DR regis-
ter.
Other transmission security methods can use
ports for handshake lines or data bytes with com-
mand fields.
Multi-master System
A multi-master system may also be configured by
the user. Transfer of master control could be im-
plemented using a handshake method through the
I/O ports or by an exchange of code messages
through the serial peripheral interface system.
The multi-master system is principally handled by
the MSTR bit in the CR register and the MODF bit
in the SR register.
MOSI
SCK
MCU
Slave
MISO
SS
ST72E311 ST72T311
MOSI
SCK
Slave
MCU
MISO
SS
73
73/101