HS7047KCM01H Renesas Electronics America, HS7047KCM01H Datasheet - Page 186

• Manufacturer Part Number: HS7047KCM01H
• Description: ON CHIP DEBUG EMULATOR
• Manufacturer: Renesas Electronics America
• Series: SuperH®r
• Type: In Circuit Debuggerr

Specifications of HS7047KCM01H

• Contents: Compact Emulator, IDE, Assembler and Linker
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: SH7047
• Lead Free Status / RoHS Status: Not Compliant, Contains lead / RoHS non-compliant

6.5.5
In the SH7047F E10A emulator, the following functions using the AUD function can be used.
These functions are operational when the AUD pin is connected to the emulator
Table 6.7
Function
Branch trace function
RAM monitor function
Notes: 1. When HS7047KCM01H and HS7047KCI01H are used, the AUD function cannot be
(1) Branch Trace Function
When a branch occurs during user program execution, the branch destination address is acquired.
When the next branch occurs while the trace information is being output, the information is
stopped and the next trace information is output. The user program can be executed in realtime,
but some trace information will not be output.
Note: After [Trace stop] is selected in [AUD mode] of the [Trace mode] page in the [Trace
162
2. When the MCU operating mode is MCU expansion mode 2, the AUD function cannot
3.
Acquisition] dialog box and the trace buffer of the emulator becomes full, the trace
information is not acquired. The user program is continuously executed.
AUD Functions
used.
be used.
Set the following before using the AUD function in the user program. The AUD
function does not operate correctly until the following is set after user program
execution is started:
AUD Functions
Set H’00FF to the PDCRL1 and PDCRL2 registers to select the following pins:
Set 1 to the PB5MD2 bit in the PBCRL1 register, 0 to the PB5MD1 bit in the
Set 1 to the AUDSRST bit in the SYSCR register and cancel the AUD reset.
AUDSYNC input/output, AUDCK input/output, AUDMD input, AUDRST input,
AUDATA3 input/output, AUDATA2 input/output, AUDATA1 input/output, and
AUDATA0 input/output.
PBCRL2 register, and 1 to the PBMD0 bit in the PBCRL2 register to select the CK
output.
Description
Displays the addresses and instruction words at the branch
destination.
Enables realtime memory reading or writing during user
program execution.