HS7047KCM01H Renesas Electronics America, HS7047KCM01H Datasheet - Page 188

• Manufacturer Part Number: HS7047KCM01H
• Description: ON CHIP DEBUG EMULATOR
• Manufacturer: Renesas Electronics America
• Series: SuperH®r
• Type: In Circuit Debuggerr

Specifications of HS7047KCM01H

• Contents: Compact Emulator, IDE, Assembler and Linker
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: SH7047
• Lead Free Status / RoHS Status: Not Compliant, Contains lead / RoHS non-compliant

6.5.6
1. The AUD trace outputs the differences between newly output branch destination addresses and
2. When a completion-type exception occurs during exception branch acquisition, the next
3. When the [Halt] option is used from the popup menu in the [Trace] window, realtime
4. In the SH7047F E10A emulator, the maximum number of trace display pointers is as follows:
5. When only one line is acquired by trace, the display data is not updated. In this case, open the
6.5.7
1. Note on Moving Source File Position after Creating Load Module
164
the previously output branch destination addresses. If the previous branch destination address
is the same as the upper 16 bits, the lower 16 bits are output. If it matches the upper 24 bits,
the lower 8 bits are output. If it matches the upper 28 bits, the lower 4 bits are output. The
emulator regenerates the 32-bit address from these differences and usually displays it in the
[Trace] window. If the emulator cannot display the 32-bit address, it displays the difference
from the previously displayed 32-bit address.
address to the address in which an exception occurs is acquired.
emulation is retained.
When HS7047KCM02H is used: D'16383 to 0
When HS7047KCI02H is used: D'65535 to 0
However, the maximum number of trace display pointers differs according to the AUD trace
information to be output. Therefore, the above pointers cannot be always acquired.
[Trace] window again.
When the source file is moved after creating the load module, the [Open] dialog box may be
displayed to specify the source file during the debugging of the created load module. Select
the corresponding source file and click the [Open] button.
Notes on Displaying the [Trace] Window
Notes on HDI