DF2505FC26V Renesas Electronics America, DF2505FC26V Datasheet - Page 460

• Manufacturer Part Number: DF2505FC26V
• Description: IC H8S/2505 MCU FLASH 144QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2500r

Specifications of DF2505FC26V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 26MHz
• Connectivity: I²C, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 104
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 144-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 13 Serial Communication Interface (SCI)
Notes: 1. Only a 0 can be written to this bit to clear the flag.
Rev. 6.00 Sep. 24, 2009 Page 412 of 928
REJ09B0099-0600
Bit
3
2
1
0
2. This bit is cleared by DTC only when DISEL is 0 with the transfer counter other than 0.
3. To clear the flag by using the CPU, write 0 to the flag and then read it once again.
Bit Name
PER
TEND
MPB
MPBT
Initial
Value
0
1
0
0
R/W
R/(W)*
R
R
R/W
1
Description
Parity Error
Indicates that a parity error occurred during reception
using parity addition in asynchronous mode, causing
abnormal termination.
[Setting condition]
•
If a parity error occurs, the receive data is transferred to
RDR but the RDRF flag is not set. Also, subsequent
serial reception cannot be continued while the PER flag
is set to 1. In clocked synchronous mode, serial
transmission cannot be continued, either.
[Clearing condition]
•
The PER flag is not affected and retains its previous state
when the RE bit in SCR is cleared to 0.
Transmit End
Indicates that transmission has been ended.
[Setting conditions]
•
•
[Clearing conditions]
•
•
Multiprocessor Bit
MPB stores the multiprocessor bit in the receive data.
When the RE bit in SCR is cleared to 0 its previous state
is retained.
Multiprocessor Bit Transfer
MPBT stores the multiprocessor bit to be added to the
transmit data.
When a parity error is detected during reception
When 0 is written to PER after reading PER = 1*
When the TE bit in SCR is 0
When TDRE = 1 at transmission of the last bit of a 1-
byte serial transmit character
When 0 is written to TDRE after reading TDRE = 1
When the DTC*
request and transfers transmit data to TDR
2
is activated by a TXI interrupt
3