DF2505FC26V Renesas Electronics America, DF2505FC26V Datasheet - Page 704

• Manufacturer Part Number: DF2505FC26V
• Description: IC H8S/2505 MCU FLASH 144QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2500r

Specifications of DF2505FC26V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 26MHz
• Connectivity: I²C, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 104
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 144-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 18 Controller Area Network (HCAN) [H8S/2556 Group]
18.7
A bus transceiver IC is necessary to connect this LSI to a CAN bus. A Philips PCA82C250
transceiver IC is recommended. Any other product must be compatible with the PCA82C250.
Figure 18.16 shows a sample connection diagram.
18.8
18.8.1
HCAN operation can be disabled or enabled using the module stop control register. The initial
setting is for HCAN operation to be halted. Register access is enabled by clearing module stop
mode. For details, see section 22, Power-Down Modes.
18.8.2
The HCAN is reset by a power-on reset or in hardware standby mode, software standby mode,
watch mode, or module stop mode. All the registers are initialized in a reset, however mailboxes
(message control (MCx[x])/message data (MDx[x])) are not. After power-on, mailboxes (message
control (MCx[x])/message data (MDx[x])) are initialized, and their values are undefined.
Therefore, mailbox initialization must always be carried out after a power-on reset or recovery
from hardware standby mode, software standby mode, watch mode, or module stop mode. The
reset interrupt flag (IRR0) is always set after a power-on reset or recovery from software standby
Rev. 6.00 Sep. 24, 2009 Page 656 of 928
REJ09B0099-0600
CAN Bus Interface
Usage Notes
Module Stop Mode Setting
Reset
Legend:
NC: No Connection
This LSI
Figure 18.16 High-Speed Interface Using PCA82C250
HRxD
HTxD
P1Vcc
NC
PCA82C250
RS
RxD
TxD
Vref
CANH
CANL
GND
Vcc
P1Vcc
124 Ω
124 Ω
CAN bus