DF2505FC26V Renesas Electronics America, DF2505FC26V Datasheet - Page 624

• Manufacturer Part Number: DF2505FC26V
• Description: IC H8S/2505 MCU FLASH 144QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2500r

Specifications of DF2505FC26V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 26MHz
• Connectivity: I²C, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 104
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 144-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 17 IEBus™ Controller (IEB) [H8S/2552 Group]
17.3.18 IEBus Transmit/Runaway Status Register (IETSR)
IETSR detects transmit data ready, transmit start, transmit normal completion, transmit
completion with an error, or runaway states. Each status flags in IETSR corresponds to a bit in the
IEBus transmit/runaway interrupt enable register (IEIET) that enables or disables each interrupt.
Rev. 6.00 Sep. 24, 2009 Page 576 of 928
REJ09B0099-0600
Bit
7
6 to 4 ⎯
3
Bit Name
TxRDY
IRA
Initial
Value
1
All 0
0
R/W
R/W
⎯
R/W
Description
Transmit Data Ready
Indicates that the next data can be written to IETBR since
IETBR is empty. This flag is automatically cleared by
DTC* data transfer. When data is transmitted by the CPU,
this flag must be cleared by software. This flag is cleared
by writing 0 after reading a 1 from this flag.
[Setting conditions]
•
•
[Clearing conditions]
•
•
Reserved
These bits are always read as 0 and cannot be modified.
IEBus Runaway State
Indicates that the on-chip microprogram for IEBus control
is in the runaway states. This flag is set to 1 when a
runaway occurs during either IEBus transmission or
reception. (This flag is not a transfer specific flag and is
also set for a reception runaway.)
[Setting condition]
•
[Clearing condition]
•
Note: This flag is not cleared on the end byte of DTC
Immediately after reset
When data can be written to IETBR (when IEB has
loaded data from IETBR to the transmit shift register.)
When writing 0 after reading TxRDY = 1
When data is written to TBR by the DTC by a TxRDY
request.
When the on-chip microprogram is in the runaway
states
When writing 0 after reading IRA = 1
transfer.