UPD70F3736GK-GAK-AX Renesas Electronics America, UPD70F3736GK-GAK-AX Datasheet - Page 744

• Manufacturer Part Number: UPD70F3736GK-GAK-AX
• Description: MCU 32BIT V850ES/JX3-L 80-LQFP
• Manufacturer: Renesas Electronics America
• Series: V850ES/Jx3-Lr

Specifications of UPD70F3736GK-GAK-AX

• Package / Case: *
• Voltage - Supply (vcc/vdd): 2.2 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Speed: 20MHz
• Number Of I /o: 66
• Core Processor: RISC
• Program Memory Type: FLASH
• Ram Size: 16K x 8
• Program Memory Size: 256KB (256K x 8)
• Data Converters: A/D 8x10b, D/A 1x8b
• Oscillator Type: Internal
• Peripherals: DMA, LVD, PWM, WDT
• Connectivity: CSI, EBI/EMI, I²C, UART/USART
• Core Size: 32-Bit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

744
(3) Serial interface pin
Table 28-8. Relationship Between FLMD0 and FLMD1 Pins and Operation Mode When Reset Is Released
The following shows the pins used by each serial interface.
When connecting a dedicated flash programmer to a serial interface pin that is connected to another device
on-board, care should be taken to avoid conflict of signals and malfunction of the other device.
(a) Conflict of signals
When the dedicated flash programmer (output) is connected to a serial interface pin (input) that is
connected to another device (output), a conflict of signals occurs. To avoid the conflict of signals, isolate
the connection to the other device or set the other device to the output high-impedance status.
V850ES/JF3-L
FLMD0
V
V
Input pin
0
DD
DD
Figure 28-12. Conflict of Signals (Serial Interface Input Pin)
UARTA0
CSIB0
CSIB0 + HS
In the flash memory programming mode, the signal that the dedicated flash
programmer sends out conflicts with signals another device outputs.
Therefore, isolate the signals on the other device side.
Table 28-9. Pins Used by Serial Interfaces
Serial Interface
Conflict of signals
Don’t care
FLMD1
Preliminary User’s Manual U18952EJ1V0UD
V
CHAPTER 28 FLASH MEMORY
0
DD
Normal operation mode
Flash memory programming mode
Setting prohibited
Dedicated flash programmer
connection pins
TXDA0, RXDA0
SOB0, SIB0, SCKB0
SOB0, SIB0, SCKB0, PCM0
Other device
Output pin
Pins Used
Operation Mode