HD64F7047F50 Renesas Electronics America, HD64F7047F50 Datasheet - Page 171

• Manufacturer Part Number: HD64F7047F50
• Description: IC SUPERH MCU FLASH 256K 100QFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7047r

Specifications of HD64F7047F50

• Core Processor: SH-2
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: CAN, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 53
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 12K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 16x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

8.4
8.4.1
The procedure for using the DTC with interrupt activation is as follows:
1. Set the DTMR, DTCRA, DTSAR, DTDAR, DTCRB, and DTIAR register information in
2. Establish the register information start address with DTBR and the DTC vector table.
3. Set the corresponding DTER bit to 1.
4. The DTC is activated when an interrupt source occurs.
5. When interrupt requests are not made to the CPU, the interrupt source is cleared, but the DTER
6. Interrupt sources are cleared within the CPU interrupt routine. When doing continuous DTC
8.4.2
The procedure for using the DTC with software activation is as follows:
1. Set the DTMR, DTCRA, DTSAR, DTDAR, DTCRB, and DTIAR register information in
2. Set the start address of the register information in the DTC vector address.
3. Check that the SWDTE bit is 0.
4. Write 1 to SWDTE bit and the vector number to DTVEC.
5. Check the vector number written to DTVEC.
6. After the end of one data transfer, if the DISEL bit is 0 and a CPU interrupt is not requested,
7. The SWDTE bit is cleared to 0 within the CPU interrupt routine. For continuous DTC data
memory space.
is not. When interrupts are requested, the interrupt source is not cleared, but the DTER is.
data transfers, set the DTER to 1.
memory space.
the SWDTE bit is cleared to 0. If the DTC is to continue transferring data, set the SWDTE bit
to 1. When the DISEL bit is 1, or after the specified number of data transfers have ended, the
SWDTE bit is held at 1 and a CPU interrupt is requested.
transfer, set the SWDTE bit to 1 after confirming that its current value is 0. Then write the
vector number to DTVEC for continuous DTC transfer.
Procedures for Using DTC
Activation by Interrupt
Activation by Software
Rev. 2.00, 09/04, page 129 of 720