EM260-RTY Ember, EM260-RTY Datasheet - Page 43

• Manufacturer Part Number: EM260-RTY
• Description: IC ZIGBEE SYSTEM-ON-CHIP 40-QFN
• Manufacturer: Ember

Specifications of EM260-RTY

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4
• Applications: ZigBee™
• Power - Output: -32dBm ~ 3dBm
• Sensitivity: -97dBm
• Voltage - Supply: 2.1 V ~ 3.6 V
• Current - Receiving: 30mA
• Current - Transmitting: 34mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 40-QFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Other names: 636-1003

EzspConfigId
EZSP_CONFIG_INDIRECT_TRANSMISSION_TIMEOUT
EZSP_CONFIG_RESERVED_ROUTING_ENTRIES
EZSP_CONFIG_MOBILE_NODE_POLL_TIMEOUT
EZSP_CONFIG_RESERVED_MOBILE_CHILD_ENTRIES
EZSP_CONFIG_HOST_RAM
EZSP_CONFIG_TX_POWER_MODE
EzspConfigTxPowerMode
EMBER_TX_POWER_MODE_DEFAULT
EMBER_TX_POWER_MODE_BOOST
EMBER_TX_POWER_MODE_ALTERNATE
EMBER_TX_POWER_MODE_BOOST_AND_ALTERNATE
EzspConfigStatus
EZSP_CONFIG_SUCCESS
EZSP_CONFIG_OUT_OF_MEMORY
EZSP_CONFIG_INVALID_VALUE
EZSP_CONFIG_INVALID_TAG
EZSP_CONFIG_INVALID_CALL
0x12
0x13
0x14
0x15
0x16
0x17
0x00
0x01
0x02
0x03
0x00
0x01
0x02
0x03
0x04
The maximum amount of time that the MAC will
hold a message for indirect transmission to a
child.
The number of route table entries that are
reserved for temporary aggregation routes in the
mesh stack.
The maximum amount of time that a mobile
node can wait between polls. If no poll is heard
within this timeout, then the parent removes the
mobile node from its tables.
The number of child table entries reserved for
use only by mobile nodes.
The amount of RAM available for use by the Host.
Enables boost power mode and/or the alternate
transmitter output.
Normal power mode and bi-directional RF trans-
mitter output.
Enable boost power mode. This is a high per-
formance radio mode which offers increased
receive sensitivity and transmit power at the cost
of an increase in power consumption.
Enable the alternate transmitter output. This
allows for simplified connection to an external
power amplifier via the RF_TX_ALT_P and
RF_TX_ALT_N pins.
Enable both boost mode and the alternate
transmitter output.
The command was successful.
Insufficient memory was available.
The value was out of bounds.
The configuration tag was not recognized.
Configuration values can no longer be modified.
120-1003-000D
EM260
43