EM260-RTY Ember, EM260-RTY Datasheet - Page 60

• Manufacturer Part Number: EM260-RTY
• Description: IC ZIGBEE SYSTEM-ON-CHIP 40-QFN
• Manufacturer: Ember

Specifications of EM260-RTY

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4
• Applications: ZigBee™
• Power - Output: -32dBm ~ 3dBm
• Sensitivity: -97dBm
• Voltage - Supply: 2.1 V ~ 3.6 V
• Current - Receiving: 30mA
• Current - Transmitting: 34mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 40-QFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Other names: 636-1003

EM260
60
120-1003-000D
6.3.6
Name: channelCalibrated
Description: Tests whether the specified channel is calibrated.
Command Parameters:
int8u channel
Response Parameters:
EmberStatus status
Name: startChannelCalibration
Description: Start calibrating the specified channel. The calibration process takes several seconds to com-
plete and the EM260 will be unresponsive until it is complete. The Host must not send another command until
the EM260 indicates that calibration is complete, using the
Command Parameters:
int8u channel
Response Parameters:
EmberStatus status
Name: calibrationCompleteHandler
Description: Informs the Host that calibration is complete and reports the result of the calibration.
This frame is a response to the
Response Parameters:
int8u channel
EmberStatus status
Networking Frames
callback
command.
The channel number to test.
EMBER_SUCCESS. The Host must wait for the
ID: 0x4B
EMBER_SUCCESS if the channel is calibrated, EM-
BER_CHANNEL_NOT_CALIBRATED if the channel is not calibrated
and EMBER_PHY_INVALID_CHANNEL if the channel is not a valid
802.15.4 channel.
ID: 0x4C
The channel to be calibrated.
pleteHandler
ID: 0x4D
The channel that was calibrated.
EMBER_SUCCESS if the channel was calibrated successfully and
EMBER_PHY_INVALID_CHANNEL if the channel was not a valid
802.15.4 channel.
calibrationCompleteHandler
callback to report the result of the calibration.
calibrationCom-
callback.