E8MS-N0 Omron, E8MS-N0 Datasheet - Page 13

• Manufacturer Part Number: E8MS-N0
• Description: SENSOR PRESSURE NEGATIV 0-101KPA
• Manufacturer: Omron
• Series: E8MSr

Specifications of E8MS-N0

• Pressure Type: Gauge
• Operating Pressure: -14.65 ~ +0 PSI, -101 ~ 0 kPa
• Port Size: Male, 1/8" (3.175mm) 27 NPT
• Output: Digital
• Voltage - Supply: 12 V ~ 24 V
• Termination Style: Cable
• Operating Temperature: 0°C ~ 50°C
• Package / Case: Module
• Sensor Output: Voltage
• Supply Current: 25mA
• Voltage Rating: 12V
• Port Style: NPT, M5
• Pressure Measurement Type: Gage
• Operating Pressure Min: 0psi
• Terminal Type: Connector
• Operating Pressure Max: 14.6psi
• Mounting Style: Desktop
• Maximum Operating Temperature: + 50 C
• Minimum Operating Temperature: 0 C
• Operating Supply Voltage: 12 V
• Output Voltage: 1 V to 5 V
• Pressure Port: Y
• Sensor Type: Sensors
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: E8MSN0

Basic Set Mode
The K3C is in measurement mode right after it is turned ON.
Press the MENU Key once to change the mode to the basic setting mode. “SET” will appear in the main display. If the mode does not
change, the key-protect function may be enabled.
ON- and OFF-point Settings
Set ON- and OFF-points for each channel.
Note: 1. The output method varies with the ON and OFF-point settings.
•
•
•
1. Press the DISPLAY Key in basic setting mode with “SET” displayed so that the OUT1 indicator will flash and the ON-point indicator
2. Press the DISPLAY Key so that the OUT1 indicator will flash and the OFF-point indicator will be lit.
3. Press the DISPLAY Key so that the OUT2 indicator will flash and the ON-point indicator will be lit.
4. Press the DISPLAY Key so that the OUT2 indicator will flash and the OFF-point indicator will be lit.
5. The set values will be entered when the MENU Key is pressed and “UNT” will appear.
Note: If the RST/ESC Key is pressed instead, the set values will not be entered, and “SET” will appear.
When the OUT1 settings are finished and the DISPLAY Key is pressed, OUT2 will be ready for setting only with the channel that has
OUT2 output.
E8M/E8MS
Measurement Mode
The Controller will be in hysteresis mode if the ON-point set
value is larger than the OFF-point set value.
The Controller will be in window mode if the OFF-point set
value is larger than the ON-point set value.
The Controller will not be in ON/OFF operation if the ON-
point value is the same as the OFF-point set value.
will be lit.
Press the Up or Down Key to change the ON-point set value of OUT1.
Press the Up or Down Key to change the OFF-point set value of OUT1.
Press the UP or Down Key to change the ON-point set value of OUT2.
Press the UP or Down Key to change the OFF-point set value of OUT2.
2. When using the E8M-A1 Minute Differential Pressure Sensor, both the ON point and OFF point must be set to the negative
setting. (They cannot be set to the positive setting.)
Basic Set Mode
14
E8M/E8MS