E8MS-N0 Omron, E8MS-N0 Datasheet - Page 23

• Manufacturer Part Number: E8MS-N0
• Description: SENSOR PRESSURE NEGATIV 0-101KPA
• Manufacturer: Omron
• Series: E8MSr

Specifications of E8MS-N0

• Pressure Type: Gauge
• Operating Pressure: -14.65 ~ +0 PSI, -101 ~ 0 kPa
• Port Size: Male, 1/8" (3.175mm) 27 NPT
• Output: Digital
• Voltage - Supply: 12 V ~ 24 V
• Termination Style: Cable
• Operating Temperature: 0°C ~ 50°C
• Package / Case: Module
• Sensor Output: Voltage
• Supply Current: 25mA
• Voltage Rating: 12V
• Port Style: NPT, M5
• Pressure Measurement Type: Gage
• Operating Pressure Min: 0psi
• Terminal Type: Connector
• Operating Pressure Max: 14.6psi
• Mounting Style: Desktop
• Maximum Operating Temperature: + 50 C
• Minimum Operating Temperature: 0 C
• Operating Supply Voltage: 12 V
• Output Voltage: 1 V to 5 V
• Pressure Port: Y
• Sensor Type: Sensors
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: E8MSN0

Window Width Change (Valid Only with One-point Teaching in Window Mode)
1. The window width set value will appear by pressing the DISPLAY Key.
2. Select the channel where hysteresis width change is required with the CH Key.
3. Press the Up or Down Key to change the set value within a range between 0% and 30% FS of the reference value as shown in the
Note: Setting to 0% FS will disable ON/OFF operation.
4. The set value is entered and “DSP” will appear by pressing the MENU Key.
Note: 1. The above settings will be invalid if the Controller is used in hysteresis mode.
Measurement Value Display Refresh Interval Change
One of the following refresh intervals can be selected.
0.1:
0.5:
1.0:
1. The display refresh interval set value will appear by pressing the DISPLAY Key.
2. Press the Up or Down Key to change the set value.
3. The set value will be entered and “AVE” will appear by pressing the MENU Key.
Note: The number of measurement times for measurement value averaging is set in the menu while “AVE” is displayed.
E8M/E8MS
following graph.
If the RST/ESC Key is pressed, set value change will be canceled and “WID” will appear.
If the RST/ESC Key is pressed, set value change will be canceled and “DSP” will appear.
2. By pressing the DISPLAY Key after OUT1 is displayed, the display will change to OUT2 only with the channel that has OUT2
Measurement values are averaged and refreshed every 0.1 s.
Measurement values are averaged and refreshed every 0.5 s.
Measurement values are averaged and refreshed every 1 s.
output.
Channel selection
with the CH Key.
Channel selection
with the CH Key.
Reference value
Value change with
the Up or Down Key.
Value change with
the Up or Down Key.
Pressure
Cancel
Cancel
(0 to 30 %)
24
Enter
Enter
E8M/E8MS