LFE2-20E-5FN484C Lattice, LFE2-20E-5FN484C Datasheet - Page 18

• Manufacturer Part Number: LFE2-20E-5FN484C
• Description: FPGA - Field Programmable Gate Array 21K LUTs 331 I/O DSP 1.2V -5
• Manufacturer: Lattice
• Series: LatticeECP2r

Specifications of LFE2-20E-5FN484C

• Number Of Macrocells: 21000
• Number Of Programmable I/os: 331
• Data Ram Size: 282624
• Supply Voltage (max): 1.26 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• Supply Voltage (min): 1.14 V
• Package / Case: FPBGA-484
• No. Of Logic Blocks: 21000
• No. Of Macrocells: 10500
• No. Of Speed Grades: 5
• Total Ram Bits: 276Kbit
• No. Of I/o's: 331
• Clock Management: DLL, PLL
• I/o Supply Voltage: 3.465V
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Architecture
Lattice Semiconductor
LatticeECP2/M Family Data Sheet
Primary Clock Routing
The clock routing structure in LatticeECP2/M devices consists of a network of eight primary clock lines (CLK0
through CLK7) per quadrant. The primary clocks of each quadrant are generated from muxes located in the center
of the device. All the clock sources are connected to these muxes. Figure 2-13 shows the clock routing for one
quadrant. Each quadrant mux is identical. If desired, any clock can be routed globally
Figure 2-13. Per Quadrant Primary Clock Selection
Primary Clock Sources: PLLs + DLLs + CLKDIVs + PIOs + Routing
35:1
35:1
35:1
35:1
35:1
35:1
32:1
32:1
32:1
32:1
DCS
DCS
CLK0
CLK1
CLK2
CLK3
CLK4
CLK5
CLK6
CLK7
8 Primary Clocks (CLK0 to CLK7) per Quadrant
Dynamic Clock Select (DCS)
The DCS is a smart multiplexer function available in the primary clock routing. It switches between two independent
input clock sources without any glitches or runt pulses. This is achieved regardless of when the select signal is tog-
gled. There are two DCS blocks per quadrant; in total, there are eight DCS blocks per device. The inputs to the
DCS block come from the center muxes. The output of the DCS is connected to primary clocks CLK6 and CLK7
(see Figure 2-13).
Figure 2-14 shows the timing waveforms of the default DCS operating mode. The DCS block can be programmed
to other modes. For more information about the DCS, please see the list of additional technical documentation at
the end of this data sheet.
Figure 2-14. DCS Waveforms
CLK0
CLK1
SEL
DCSOUT
Secondary Clock/Control Routing
Secondary clocks in the LatticeECP2 devices are region-based resources. The benefit of region-based resources
is the relatively low injection delay and skew within the region, as compared to primary clocks. EBR/DSP rows and
a special vertical routing channel bound the secondary clock regions. This special vertical routing channel aligns
with either the left edge of the center DSP block in the DSP row or the center of the DSP row. Figure 2-15 shows
2-15