HC230F1020 Altera, HC230F1020 Datasheet - Page 43

• Manufacturer Part Number: HC230F1020
• Manufacturer: Altera

Specifications of HC230F1020

• Lead Free Status / RoHS Status: Not Compliant

Introduction
Absolute
Maximum
Ratings
Altera Corporation
September 2008
Notes to
(1)
(2)
(3)
(4)
V
V
V
V
V
V
I
T
T
H51018-3.3
OUT
Table 4–1. HardCopy II Device Absolute Maximum Ratings
Symbol
STG
J
CCINT
CCIO
CCPD
CCA
CCD
I
Refer to the Operating Requirements for Altera Devices Data Sheet for more information.
Conditions beyond those listed in
operation at the absolute maximum ratings for extended periods of time may have adverse effects on the device.
Supply voltage specifications apply to voltage readings taken at the device pins, not at the power supply.
During transitions, the inputs may overshoot to the voltage shown in
The DC case is equivalent to a 100% duty cycle. During transitions, the inputs may undershoot to –2.0 V for input
currents less than 100 mA and periods shorter than 20 ns.
Table
4–1:
DC output current, per pin
Analog power supply for
Digital power supply for
Junction temperature
Storage temperature
DC input voltage(4)
Supply voltage
Supply voltage
Supply voltage
Parameter
PLLs
PLLs
This chapter provides preliminary information on absolute maximum
ratings, recommended operating conditions, DC electrical characteristics,
and other specifications for HardCopy
HardCopy II devices are offered in both commercial and industrial
grades. All parameter limits are representative of worst-case supply
voltage and junction temperature conditions. Unless otherwise noted, the
parameter values in this chapter apply to all HardCopy II devices.
Table 4–1
device family.
Table 4–1
contains the absolute maximum ratings for the HardCopy II
may cause permanent damage to a device. Additionally, device
Specifications and Operating
With respect to ground
With respect to ground
With respect to ground
With respect to ground
With respect to ground
Ball-grid array (BGA)
packages under bias
Conditions
No bias
—
—
Notes
4. DC and Switching
Table 4–2
(1), (2),
®
II devices.
Minimum
based upon the input duty cycle.
-0.5
-0.5
-0.5
-0.5
-0.5
-0.5
(3)
-25
-65
-55
Conditions
Maximum
150
125
1.8
4.6
4.6
1.8
1.8
4.6
40
Preliminary
Unit
mA
°
°
V
V
V
V
V
V
C
C
4–1