S9S08SG16E1CTJ Freescale, S9S08SG16E1CTJ Datasheet - Page 179

• Manufacturer Part Number: S9S08SG16E1CTJ
• Manufacturer: Freescale

Specifications of S9S08SG16E1CTJ

• Cpu Family: HCS08
• Device Core Size: 8b
• Frequency (max): 40MHz
• Interface Type: SCI/SPI
• Total Internal Ram Size: 1KB
• # I/os (max): 16
• Number Of Timers - General Purpose: 1
• Operating Supply Voltage (typ): 3.3/5V
• Operating Supply Voltage (max): 5.5V
• Operating Supply Voltage (min): 2.7V
• On-chip Adc: 12-chx10-bit
• Instruction Set Architecture: CISC
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 20
• Package Type: TSSOP
• Program Memory Type: Flash
• Program Memory Size: 16KB
• Lead Free Status / RoHS Status: Compliant

11.4
11.4.1
The seven states of the ICS are shown as a state diagram and are described below. The arrows indicate the
allowed movements between the states.
11.4.1.1
FLL engaged internal (FEI) is the default mode of operation and is entered when all the following
conditions occur:
Freescale Semiconductor
FLL Bypassed
External Low
Power(FBELP)
Field
IREFS=0
CLKS=10
BDM Disabled
and LP=1
1
0
Functional Description
Operational Modes
OSC Initialization — If the external reference clock is selected by ERCLKEN or by the ICS being in FEE, FBE,
or FBELP mode, and if EREFS is set, then this bit is set after the initialization cycles of the external oscillator
clock have completed. This bit is only cleared when either ERCLKEN or EREFS are cleared.
ICS Fine Trim — The FTRIM bit controls the smallest adjustment of the internal reference clock frequency.
Setting FTRIM will increase the period and clearing FTRIM will decrease the period by the smallest amount
possible.
FLL Engaged Internal (FEI)
Entered from any state
when MCU enters stop
Table 11-5. ICS Status and Control Register Field Descriptions (continued)
IREFS=0
CLKS=10
BDM Enabled
or LP =0
FLL Bypassed
External (FBE)
Figure 11-7. Clock Switching Modes
MC9S08SG32 Data Sheet, Rev. 8
FLL Engaged
External (FEE)
FLL Engaged
Internal (FEI)
IREFS=1
CLKS=00
IREFS=0
CLKS=00
Stop
Description
Chapter 11 Internal Clock Source (S08ICSV2)
FLL Bypassed
Internal (FBI)
Returns to state that was active
before MCU entered stop, unless
RESET occurs while in stop.
IREFS=1
CLKS=01
BDM Enabled
or LP=0
FLL Bypassed
Internal Low
Power(FBILP)
IREFS=1
CLKS=01
BDM Disabled
and LP=1
179