IXB28504XGBEFS Intel, IXB28504XGBEFS Datasheet - Page 150

• Manufacturer Part Number: IXB28504XGBEFS
• Manufacturer: Intel

Specifications of IXB28504XGBEFS

• Lead Free Status / Rohs Status: Compliant

11.3.2.4
11.3.2.5
11.3.2.6
Intel NetStructure
TPS
150
®
fis sdr_upgrade
The full syntax of this command is:
fis sdr_upgrade [-a] | [-f] | -i <imagename> [-c <bb|npmod|fic|db1|db2|mic1|mic2>]
This command is used to update the Sensor Data Record (SDR) on all (-a option) or
specific (-c option) components. The recognized parameters are:
fis ssu_upgrade
The full syntax of this command is:
fis ssu_upgrade [-o] -a | -i <bmc|redboot|linux|rootfs|target>
Upgrade an element using the Safe System Upgrade (SSU) mechanism. The images
currently present are printed in “SSU-capable images” section of fis manifest command
(see
After executing the fis ssu_upgrade command, the following command sequence should
be used to validate the operation and check the firmware components configuration:
fis fis_upgrade
The full syntax of this command is:
fis fis_upgrade -i <redboot|linux|rootfs|target|diag> [partition]
This command burns the specified image to the specified partition. The currently
present images are printed in “SSU-capable images” and “Other images” sections of fis
manifest command. The only recognized option is:
• -a - Upgrade all visible components using their FRU information to determine the
• -i - Use a specific image for update (see
• -f - Use the FRU information to determine which image should be used for the
• -o - Set upgraded component(s) in SSU_ONESHOT mode
• -a - Upgrade all available components
• -i - Identifies the image to be burned in flash. Possible images are:
IXB2850 Packet Processing Boards
image to be used for the update
OR
-c - Upgrade a specific component
page 148
update
OR
-i - Upgrade a specific component (if present in the appimage).
Appimage> reset
....
RedBoot> reset bmc
RedBoot> ssu validate -i all
RedBoot> cfg verify
Section 11.3.2.2, “fis manifest” on page
— redboot - Redboot* boot monitor
— linux - Linux
— rootfs - Linux root file system
for the names of the images)
Section 11.3.2.2, “fis manifest” on
148). The recognized parameters are:
Document Number: 05-2443-006
IXB2850—Maintenance
January 2007