20-101-0356 Rabbit Semiconductor, 20-101-0356 Datasheet - Page 14

• Manufacturer Part Number: 20-101-0356
• Description: COMPUTER SINGLE-BOARD BL1800
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0356

• Module/board Type: Single Board Computer Module
• Product: Modules
• Data Bus Width: 8 bit
• Processor Type: Rabbit 2000
• Sram: 128 KB
• Flash: 256 KB
• Timers: 8 bit, 10 bit
• Number Of I/os: 14
• Backup Battery: 3 V Lithium Coin Type
• Operating Voltage: 8 V to 40 V
• Power Consumption: 1.2 W
• Board Size: 89 mm x 64 mm x 19 mm
• Description/function: Computer Module
• For Use With/related Products: BL1800
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1079

2.2.2 Connect Programming Cable
The programming cable connects the Jackrabbit to the PC running Dynamic C to down-
load programs and to monitor the Jackrabbit during debugging.
Connect the 10-pin connector of the programming cable labeled
the Jackrabbit board as shown in Figure 2. Be sure to orient the marked (usually red) edge
of the cable towards pin 1 of the connector. (Do not use the
for a normal serial connection.)
Connect the other end of the programming cable to a COM port on your PC.
10
NOTE: Use only the programming cable that has a red shrink wrap around the RS-232
NOTE: Never disconnect the programming cable by pulling on the ribbon cable.
NOTE: Some PCs now come equipped only with a USB port. It may be possible to use
level converter (Part No. 20-101-0513), which is supplied with the Development Kit.
Other Rabbit programming cables are not voltage-compatible or their connector sizes
may be different.
Carefully pull on the connector to remove it from the header.
an RS-232/USB converter (Part No. 20-151-0178) with the programming cable sup-
plied with the Jackrabbit Development Kit. Note that not all RS-232/USB converters
work with Dynamic C.
Figure 2. Power and Programming Cable Connections
to Jackrabbit Board
DIAG
PROG
connector, which is used
to header J3 on
Jackrabbit (BL1800)