20-101-0356 Rabbit Semiconductor, 20-101-0356 Datasheet - Page 88

• Manufacturer Part Number: 20-101-0356
• Description: COMPUTER SINGLE-BOARD BL1800
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0356

• Module/board Type: Single Board Computer Module
• Product: Modules
• Data Bus Width: 8 bit
• Processor Type: Rabbit 2000
• Sram: 128 KB
• Flash: 256 KB
• Timers: 8 bit, 10 bit
• Number Of I/os: 14
• Backup Battery: 3 V Lithium Coin Type
• Operating Voltage: 8 V to 40 V
• Power Consumption: 1.2 W
• Board Size: 89 mm x 64 mm x 19 mm
• Description/function: Computer Module
• For Use With/related Products: BL1800
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1079

The battery-backup circuit serves two purposes:
• It reduces the battery voltage to the real-time clock, thereby reducing the current con-
sumed by the real-time clock and lengthening the battery life.
• It ensures that current can flow only out of the battery to prevent charging the battery.
C.2.2 Power to VRAM Switch
The VRAM switch, shown in Figure C-6, allows the soldered-in battery to provide power
when the external power goes off. The switch provides an isolation between Vcc and the
battery when Vcc goes low. This prevents the Vcc line from draining the battery.
W
W
W
Figure C-6. VRAM Switch
Transistor Q23 is needed to provide a very small voltage drop between Vcc and VRAM
(<100 mV, typically 10 mV) so that the processor lines powered by Vcc will not have a
significantly different voltage than VRAM.
When the Jackrabbit is not resetting (pin 2 on U21 is high), the /RES line will be high.
This turns on Q24, causing its collector (pin 3) to go low. This turns on Q23, allowing
VRAM to nearly equal Vcc.
When the Jackrabbit is resetting, the /RES line will go low. This turns off Q23 and Q24,
providing an isolation between Vcc and VRAM.
The battery backup circuit keeps VRAM from dropping below 2 V.
C.2.3 Reset Generator
The Jackrabbit uses a reset generator, U21, to reset the Rabbit 2000 microprocessor when
the voltage drops below the voltage necessary for reliable operation. The Jackrabbit does
not have a reset output presented to the headers. The reset generator has a reset input that
can be used to force the Jackrabbit to reset. This input is available on headers J3 and J5,
and also on pads directly below header J5. The two pads allow a screwdriver to be used to
short the pads, forcing a reset.
84
Jackrabbit (BL1800)