20-101-0356 Rabbit Semiconductor, 20-101-0356 Datasheet - Page 31

• Manufacturer Part Number: 20-101-0356
• Description: COMPUTER SINGLE-BOARD BL1800
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0356

• Module/board Type: Single Board Computer Module
• Product: Modules
• Data Bus Width: 8 bit
• Processor Type: Rabbit 2000
• Sram: 128 KB
• Flash: 256 KB
• Timers: 8 bit, 10 bit
• Number Of I/os: 14
• Backup Battery: 3 V Lithium Coin Type
• Operating Voltage: 8 V to 40 V
• Power Consumption: 1.2 W
• Board Size: 89 mm x 64 mm x 19 mm
• Description/function: Computer Module
• For Use With/related Products: BL1800
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1079

The resolution of the DA0 output depends on the smallest increment of time to change the
on/off time (the time between 5 V and 0 V). The Jackrabbit uses the Rabbit 2000’s Port D
control registers to clock out the signal at a timer timeout. The timer used is timer B.
Timer B has 10 bits of resolution so that the voltage can be varied in 1/1024 increments.
The resolution is thus about 3.88 mV for the DA0 output voltage range of 0 V to 3 V in the
12%–88% duty cycle.
An LM324 op amp, which can comfortably source 10 mA throughout the D/A converter
range, drives the D/A converter output. If the output voltage is above 1 V, the D/A con-
verter can comfortably sink 10 mA. Below 1 V, the D/A converter can only sink a maxi-
mum of 100 µA.
The peak-to-peak ripple on DA0 is less than 3 mV. There is a way to get rid of the ripple
for very small periods of time. To do that, simply program the PWM port from a PWM
output to a high-impedance input. This will allow the capacitor to hold the voltage subject
only to leakage currents, which add up to about 1 µA. This will cause the capacitor to
change voltage at the rate of 10 V per second, or 10 mV per millisecond. Practically, this
means that the PWM can stop for about 1 ms (seven 1024-count D/A converter cycles on
a 14.74 MHz processor clock) with a voltage movement of less than 10 mV.
To summarize, DA0 is provided uncalibrated, can be programmed with a resolution of
3.88 mV and a peak-to-peak ripple less than 3 mV over the range from 0.1 V to 2.8 V and
at 3.35 V. The settling time to within 3 mV is 54 ms.
User’s Manual
27