MD4331-d1G-MECH M-Systems Inc., MD4331-d1G-MECH Datasheet - Page 13

• Manufacturer Part Number: MD4331-d1G-MECH
• Description: Mobile Diskonchip G3 Data Sheet
• Manufacturer: M-Systems Inc.

2.2.3
Mobile DiskOnChip G3 TSOP-I and FBGA packages support identical signals. The related pin and
ball designations are listed in the signal descriptions, presented in logic groups, in Table 1 and
Table 2.
TSOP-I Package
10
A[12:6]
A[5:0]
D[15:8]
D[7:0]
CE#
WE#
OE#
ID[1:0]
LOCK#
IF_CFG
BUSY#
RSTIN#
CLK
Signal
Table 1: Signal Descriptions for Standard Interface (Mobile DiskOnChip 512Mb TSOP-I Package)
Signal Description
Pin No.
26, 24
14-19
46-39
35-28
5-11
23
22
38
27
2
3
4
1
ST, R8 Data bus, high byte. Not used and may be left
Input
Type
OD
ST
ST
ST
ST
ST
ST
ST
ST
ST
ST
Data bus, low byte.
System Clock.
Address bus. A0 is multiplexed with the DPD pin.
floating when IF_CFG is set to 0 (8-bit mode).
Chip Enable, active low
Write Enable, active low
Output Enable, active low
Identification. Configuration control to support up to
four chips cascaded in the same memory window.
Chip 1 = ID1, ID0 = VSS, VSS (0,0); must be used
Chip 2 = ID1, ID0 = VSS, VCCQ (0,1)
Chip 3 = ID1, ID0 = VCCQ, VSS (1,0)
Chip 4 = ID1, ID0 = VCCQ, VCCQ (1,1)
Lock, active low. When active, provides full
hardware data protection of selected partitions.
Interface Configuration, 1(VCCQ) for 16-bit
interface mode, 0 (VSS) for 8-bit interface mode.
Busy, active low, open drain. Indicates that
DiskOnChip is initializing and should not be
accessed. A 10 KΩ pull-up resistor is required if
this pin drives an input. A 10 KΩ pull-up resistor is
recommended even if this pin is not used.
Reset, active low.
Data Sheet, Rev. 1.0
System Interface
Configuration
Control
Description
for single-chip configuration
Mobile DiskOnChip G3
91-SR-011-05-8L
Signal
Output
Output
Output
Input/
Input/
Type
Input
Input
Input
Input
Input
Input
Input
Input
Input