MD4331-d1G-MECH M-Systems Inc., MD4331-d1G-MECH Datasheet - Page 14

• Manufacturer Part Number: MD4331-d1G-MECH
• Description: Mobile Diskonchip G3 Data Sheet
• Manufacturer: M-Systems Inc.

11
The following abbreviations are used: IN - Standard (non-Schmidt) input, ST - Schmidt Trigger input, OD - Open drain output, R8 - Nominal
22K pull-up resistor, enabled only for 8-bit interface mode (IF_CFG input is 0)
DMARQ#
IRQ#
DPD
VCC
VCCQ
VSS
RSRVD
Signal
13, 25, 36, 48
Pin No.
47
19
12
37
20
21
Input
Type
OD
OD
ST
-
-
-
-
Device core power supply. Requires a 10 nF and
I/O power supply. Sets the logic 1 voltage level
DMA Request, active low. A 10 KΩ pull-up resistor
is required if this pin drives an input. A 10 KΩ pull-
up resistor is recommended even if this pin is not
used.
Interrupt Request, active low. A 10 KΩ pull-up
resistor is required if this pin drives an input. A 10
KΩ pull-up resistor is recommended even if this pin
is not used.
Deep Power-Down. Used to enter and exit Deep
Power-Down mode. This pin is assigned A0
instead of DPD when working in 8-bit mode.
0.1 µF capacitor.
range of I/O pins. VCCQ may be either 2.5V to
3.6V or 1.65V to 2.0V. Requires a 10 nF and
0.1 µF capacitor.
Ground. All VSS pins must be connected.
Reserved. All reserved signals are not connected
internally and must be left floating to guarantee
forward compatibility with future products.
Data Sheet, Rev. 1.0
Power
Other
Description
Mobile DiskOnChip G3
91-SR-011-05-8L
Supply
Supply
Supply
Signal
Output
Output
Type
Input