upd78f0114hgb-8es-a Renesas Electronics Corporation., upd78f0114hgb-8es-a Datasheet - Page 128

• Manufacturer Part Number: upd78f0114hgb-8es-a
• Description: 8-bit Single-chip Microcontrollers
• Manufacturer: Renesas Electronics Corporation.

(1) TI000 pin valid edge selected as capture trigger (CRC001 = 1, CRC000 = 1)
(2) TI010 pin valid edge selected as capture trigger (CRC001 = 0, CRC000 = 1)
Remarks 1. Setting ES001, ES000 = 1, 0 and ES101, ES100 = 1, 0 is prohibited.
128
Falling edge
Rising edge
No capture operation
Falling edge
Rising edge
Both rising and falling edges
Cautions 1. Set a value other than 0000H in CR000 in the mode in which clear & start occurs on a match
CR000 Capture Trigger
CR000 Capture Trigger
2. ES001, ES000:
ES101, ES100:
CRC001, CRC000: Bits 1 and 0 of capture/compare control register 00 (CRC00)
2. If CR000 is set to 0000H in the free-running mode and in the clear mode using the valid edge
3. When the valid edge of the TI010 pin is used, P01 or P06 cannot be used as the timer output
4. When CR000 is used as a capture register, read data is undefined if the register read time
5. Do not rewrite CR000 during TM00 operation.
Table 6-2. CR000 Capture Trigger and Valid Edges of TI000 and TI010 Pins
of TM00 and CR000.
of the TI000 pin, an interrupt request (INTTM000) is generated when the value of CR000
changes from 0000H to 0001H following TM00 overflow (FFFFH). Moreover, INTTM000 is
generated after a match of TM00 and CR000 is detected, a valid edge of the TI010 pin is
detected, or the timer is cleared by a one-shot trigger.
pin (TO00). When P01 or P06 is used as the TO00 pin, the valid edge of the TI010 pin cannot
be used.
and capture trigger input conflict (the capture data itself is the correct value). If a timer
count stop and a capture trigger input conflict, the captured data is undefined.
CHAPTER 6 16-BIT TIMER/EVENT COUNTER 00
Bits 5 and 4 of prescaler mode register 00 (PRM00)
Bits 7 and 6 of prescaler mode register 00 (PRM00)
Rising edge
Falling edge
Both rising and falling edges
Falling edge
Rising edge
Both rising and falling edges
User’s Manual U16961EJ4V0UD
TI000 Pin Valid Edge
TI010 Pin Valid Edge
ES001
ES101
0
0
1
0
0
1
ES000
ES100
1
0
1
0
1
1