st7fmc2s7t6 STMicroelectronics, st7fmc2s7t6 Datasheet - Page 267

• Manufacturer Part Number: st7fmc2s7t6
• Description: 8-bit Mcu With Nested Interrupts, Flash, 10-bit Adc, Brushless Motor Control, Five Timers, Spi, Linsci
• Manufacturer: STMicroelectronics

CONTROL PIN CHARACTERISTICS (Cont’d)
Figure 144. RESET pin protection when LVD is enabled.
Figure 145. RESET pin protection when LVD is disabled.
Note 1:
Note 2: When the LVD is enabled, it is recommended not to connect a pull-up resistor or capacitor. A 10nF pull-down
capacitor is required to filter noise on the reset line.
Note 3: In case a capacitive power supply is used, it is recommended to connect a 1M pull-down resistor to the RESET
pin to discharge any residual voltage induced by the capacitive effect of the power supply (this will add 5µA to the power
consumption of the MCU).
Note 4: Tips when using the LVD:
Note 5: Please refer to
– The reset network protects the device against parasitic resets.
– The output of the external reset circuit must have an open-drain output to drive the ST7 reset pad. Otherwise the
– Whatever the reset source is (internal or external), the user must ensure that the level on the RESET pin can go
– Because the reset circuit is designed to allow the internal RESET to be output in the RESET pin, the user must en-
– 1. Check that all recommendations related to ICCCLK and reset circuit have been applied (see notes above)
– 2. Check that the power supply is properly decoupled (100nF + 10µF close to the MCU). Refer to AN1709 and
– 3. The capacitors connected on the RESET pin and also the power supply are key to avoid any start-up marginality.
EXTERNAL
device can be damaged when the ST7 generates an internal reset (LVD, illegal opcode or watchdog).
below the V
internally.
sure that the current sunk on the RESET pin is less than the absolute maximum value specified for I
section 12.2.2 on page
AN2017. If this cannot be done, it is recommended to put a 100nF + 1M pull-down on the RESET pin.
In most cases, steps 1 and 2 above are sufficient for a robust solution. Otherwise: replace 10nF pull-down on the
RESET pin with a 5µF to 20µF capacitor.”
RESET
Required
EXTERNAL
CIRCUIT
RESET
USER
Required
IL
max. level specified in
0.01 F
“Illegal Opcode Reset” on page 243
247.
0.01 F
1M
Optional
(note 3)
section 12.9.1 on page
V
V
DD
DD
R
R
for more details on illegal opcode reset conditions
ON
ON
Filter
Filter
266. Otherwise the reset will not be taken into account
1)2)3)4)
GENERATOR
1)
GENERATOR
PULSE
PULSE
WATCHDOG
ILLEGAL OPCODE
LVD RESET
ST7MC1/ST7MC2
WATCHDOG
ILLEGAL OPCODE
INTERNAL
RESET
INTERNAL
RESET
INJ(RESET)
ST72XXX
ST72XXX
267/308
5)
5)
in