mc68hc908ld64 Freescale Semiconductor, Inc, mc68hc908ld64 Datasheet - Page 127

• Manufacturer Part Number: mc68hc908ld64
• Description: M68hc08 Microcontrollers Microcontroller
• Manufacturer: Freescale Semiconductor, Inc

9.6.1.2 SWI Instruction
9.6.2 Interrupt Status Registers
MC68HC908LD64
Freescale Semiconductor
NOTE:
NOTE:
—
Rev. 3.0
The LDA opcode is pre-fetched by both the INT1 and INT2 RTI
instructions. However, in the case of the INT1 RTI pre-fetch, this is a
redundant operation.
To maintain compatibility with the M6805 Family, the H register is not
pushed on the stack during interrupt entry. If the interrupt service routine
modifies the H register or uses the indexed addressing mode, software
should save the H register and then restore it prior to exiting the routine.
The SWI instruction is a non-maskable instruction that causes an
interrupt regardless of the state of the interrupt mask (I bit) in the
condition code register.
A software interrupt pushes PC onto the stack. A software interrupt does
not push PC – 1, as a hardware interrupt does.
The flags in the interrupt status registers identify maskable interrupt
sources.
status register flags that they set. The interrupt status registers can be
useful for debugging.
Table 9-3
System Integration Module (SIM)
summarizes the interrupt sources and the interrupt
System Integration Module (SIM)
Exception Control
Data Sheet
127