at91sam9g20-cu ATMEL Corporation, at91sam9g20-cu Datasheet - Page 671

• Manufacturer Part Number: at91sam9g20-cu
• Description: At91 Arm Thumb Microcontrollers
• Manufacturer: ATMEL Corporation

37.3.2
37.3.3
6384B–ATARM–15-Dec-08
Power Management
Interrupt
To reserve an I/O line to check VBUS, the programmer must first program the PIO controller to
assign this I/O in input PIO mode.
The USB device peripheral requires a 48 MHz clock. This clock must be generated by a PLL
with an accuracy of ± 0.25%.
Thus, the USB device receives two clocks from the Power Management Controller (PMC): the
master clock, MCK, used to drive the peripheral user interface, and the UDPCK, used to inter-
face with the bus USB signals (recovered 12 MHz domain).
WARNING: The UDP peripheral clock in the Power Management Controller (PMC) must be
enabled before any read/write operations to the UDP registers including the UDP_TXCV
register.
The USB device interface has an interrupt line connected to the Advanced Interrupt Controller
(AIC).
Handling the USB device interrupt requires programming the AIC before configuring the UDP.
AT91SAM9G20 Preliminary
671