MC68HC908JL8 MOTOROLA [Motorola, Inc], MC68HC908JL8 Datasheet - Page 196

• Manufacturer Part Number: MC68HC908JL8
• Description: Motorola reserves the right to make changes without further notice to any products herein
• Manufacturer: MOTOROLA [Motorola, Inc]

Serial Communications Interface (SCI)
11.9.3 SCI Control Register 3
Technical Data
196
NOTE:
NOTE:
Writing to the RE bit is not allowed when the enable SCI bit (ENSCI) is
clear. ENSCI is in SCI control register 1.
RWU — Receiver Wakeup Bit
SBK — Send Break Bit
Do not toggle the SBK bit immediately after setting the SCTE bit.
Toggling SBK before the preamble begins causes the SCI to send a
break character instead of a preamble.
SCI control register 3:
Freescale Semiconductor, Inc.
This read/write bit puts the receiver in a standby state during which
receiver interrupts are disabled. The WAKE bit in SCC1 determines
whether an idle input or an address mark brings the receiver out of the
standby state and clears the RWU bit. Reset clears the RWU bit.
Setting and then clearing this read/write bit transmits a break
character followed by a logic 1. The logic 1 after the break character
guarantees recognition of a valid start bit. If SBK remains set, the
transmitter continuously transmits break characters with no logic 1s
between them. Reset clears the SBK bit.
•
•
•
For More Information On This Product,
1 = Standby state
0 = Normal operation
1 = Transmit break characters
0 = No break characters being transmitted
Stores the ninth SCI data bit received and the ninth SCI data bit to
be transmitted
Enables these interrupts:
– Receiver overrun interrupts
– Noise error interrupts
– Framing error interrupts
Parity error interrupts
Serial Communications Interface (SCI)
Go to: www.freescale.com
MC68HC908JL8
MOTOROLA
—
Rev. 2.0