MC68HC908JL8 MOTOROLA [Motorola, Inc], MC68HC908JL8 Datasheet - Page 213

• Manufacturer Part Number: MC68HC908JL8
• Description: Motorola reserves the right to make changes without further notice to any products herein
• Manufacturer: MOTOROLA [Motorola, Inc]

MC68HC908JL8
MOTOROLA
NOTE:
—
Rev. 2.0
AIEN — ADC Interrupt Enable Bit
ADCO — ADC Continuous Conversion Bit
ADCH[4:0] — ADC Channel Select Bits
Recovery from the disabled state requires one conversion cycle to
stabilize.
When this bit is set, an interrupt is generated at the end of an ADC
conversion. The interrupt signal is cleared when the data register is
read or the status/control register is written. Reset clears the AIEN bit.
When set, the ADC will convert samples continuously and update the
ADR register at the end of each conversion. Only one conversion is
allowed when this bit is cleared. Reset clears the ADCO bit.
ADCH[4:0] form a 5-bit field which is used to select one of the ADC
channels. The five channel select bits are detailed in the following
table. Care should be taken when using a port pin as both an analog
and a digital input simultaneously to prevent switching noise from
corrupting the analog signal. (See
The ADC subsystem is turned off when the channel select bits are all
set to one. This feature allows for reduced power consumption for the
MCU when the ADC is not used. Reset sets all of these bits to a
logic 1.
Freescale Semiconductor, Inc.
For More Information On This Product,
1 = ADC interrupt enabled
0 = ADC interrupt disabled
1 = Continuous ADC conversion
0 = One ADC conversion
Analog-to-Digital Converter (ADC)
Go to: www.freescale.com
Table
Analog-to-Digital Converter (ADC)
12-1.)
Technical Data
I/O Registers
213